Most Maytag washer repairs in Orem involve the same few systems: the drain pump, the lid or door lock, the drive, the water supply and the controls. The Orem list starts with companies that name Maytag, followed by other appliance repair companies that work on washers.
This is an independent directory. We are not affiliated with Maytag, and the technicians listed are independent repair companies, not the manufacturer.
Independent Maytag Washer Technicians, Orem UT
We found 40 appliance repair companies within 30 miles of Orem. 9 list an address in Orem, and the rest are spread across Provo (7), American Fork (5), and Springville (4). The farthest listed company is about 12 miles out. Nearest on the list: Renew Orem Appliance Repair, around 1.0 miles out. None of the repair companies near Orem name Maytag in their listings, so we show the closest appliance repair companies. Ask each one about your machine before booking. The 27 rated companies in range average 4.4 stars.
Companies are shown by relevance and distance from Orem. A mention does not mean manufacturer certification, so ask each company about its experience with your washer.
| Rated 4.5 stars or higher (10+ reviews) | 11 |
|---|---|
| Three nearest companies, miles away | 1.0, 1.1, 1.2 |
| Mention washer work | 4 |
| Repair companies inside 30 miles | 60 |
| Mention Maytag | 0 |
| Listing Saturday hours | 42 |
The leading options for Orem are Brothers Masters (2.2 miles away, based in Provo, 5.0 stars from 30 reviews, lists Saturday hours); Refrigerate (3.1 miles away, based in Lindon, 4.0 stars from 297 reviews, lists Saturday hours); Utah Appliance Rental (1.8 miles away, 4.9 stars from 51 reviews, lists Saturday hours); Blue Collar Appliance Co. (2.7 miles away, 5.0 stars from 25 reviews, lists Saturday hours).
Know Your Maytag Washer
How Maytag Washers Are Built
Top load HE models use auto-sensing, spinning slowly to estimate the load before adding water in stages, so the water level can look lower than owners expect. Source: Maytag Product Help - Auto Sensing in a Top Load HE Washer
A liquid-filled balance ring at the top of the tub shifts to offset uneven loads so the basket stays steady at higher spin speeds. Source: Maytag Product Help - Water Heard in Washer, but not Seen - Balance Ring Information
Maytag Washer Symptoms and First Checks
- Washer leaking. Maytag points first to loose inlet hose connections or missing hose washers, then to the drain hose and a backed-up household drain, and to clothes added mid-cycle that raise the water over the tub. Source: Maytag Product Help - Leaking Water Underneath - Washer
- Off balance, shaking or walking. Maytag says to spread the load evenly, confirm the shipping bolts were removed, and level the washer so all four feet sit firmly on the floor. Source: Maytag Product Help - Washer is Vibrating, Walking or Moving
Maytag Washer Error Codes
| Code | What it means |
|---|---|
| F5E3 | Top load: lid lock problem; Maytag suggests a five-minute power reset first. Source: Maytag Product Help - F5E3 - Error Code |
| F9E1 | Top load: long drain, usually tied to a kinked, clogged or improperly installed drain hose. Source: Maytag Product Help - F9E1 - Error Code |
| F5E2 | Top load: the lid lock cannot engage, often because something is obstructing the lock area. Source: Maytag Product Help - F5E2 - Error Code |
Maytag Washer Problems Worth a Service Call
- Water left in the drum after the cycle
- Musty or mildew smell from the drum or door seal
- Burning smell or a motor that hums without turning
Inside a Washer Repair Visit
Keeping a Maytag Washer Running
- If fill is slow, shut off the water, remove the inlet hoses and scrub clogged inlet screens on the back of the water valve with a brush and mild soap. Source: Maytag Product Help - Checking the Fill Hoses if the Washer is not Filling
- Use only HE detergent in HE washers and measure it per the detergent maker's directions, since too much causes oversudsing, poor rinsing and residue. Source: Maytag Product Help - HE Detergent use in a Washer
Brand guides: Maytag Washer Not Draining or Spinning: Causes.
Budgeting for a Maytag Washer Repair
Most Maytag washer repairs involve common parts and an hour or two of labor. For reference, published cost guides report:
- Control board (motherboard) replacement: $250–$400 Source: Fixr - How much does it cost to repair a washing machine?
- Drain hose replacement: $95–$170 Source: Fixr - How much does it cost to repair a washing machine?
- Door lock replacement: $110–$200 Source: Fixr - How much does it cost to repair a washing machine?
- After-hours / emergency visit surcharge: $100–$200 per visit Source: Fixr - How much does it cost to repair a washing machine?
50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?
Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.
What to Have Ready for a Maytag Washer Call
- Any error code shown on the display
- Where the washer drains (standpipe or laundry sink)
- Whether it is a front loader, a top loader with an agitator, or a top loader with an impeller
Around Orem
Most washer calls in Orem come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.
Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308
In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.
Questions to Ask a Orem Washer Technician
- Is your company licensed where my state requires it, and insured?
- If the washer is leaking, will you find where the water starts before quoting a part?
- Will you check the drain pump filter and drain hose before replacing the pump?
Maytag Washer Repair FAQs: Orem, UT
Why won't my washer spin?
Why does my front-load washer smell?
What should I do about a Maytag error code?
Other Washer Repair in Orem
More Maytag Washer Repair Pages Nearby
Write down any error code your Maytag washer shows and at what point in the cycle it appears. It helps a Orem technician bring the right parts.