Serving Washington Terrace, Utah and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Washington Terrace, UT

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve Washington Terrace.

Water sitting in the washer in Washington Terrace?
Tell us the brand and the problem and we will connect you with a technician near Washington Terrace.
☎(866) 293-4411
✓12 companies listed for Washington Terrace✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. Below are the companies within reach of Washington Terrace, sorted by how closely they match washing machine work, then by distance and public ratings.

Who Repairs Washers Near Washington Terrace

40 repair companies serve Washington Terrace from within 30 miles. Other nearby bases include Salt Lake City (14), Ogden (3), and Clearfield (3). Nearest on the list: Reliable Appliance Repair Specialists, around 1.6 miles out. 1 of them mentions washing machine or washer work in their listing or website. The 28 rated companies in range average 4.5 stars.

Appliance Repair
iFiX, LLC
5187 1500 W #1, Riverdale, UT 84405
2.0 mi from Washington Terrace
★★★★★ 4.9 (436 reviews)
Washer & Dryer Repair
Sears Home Services Appliance Repair
1338 Jefferson St, Salt Lake City, UT 84115
29.9 mi from Washington Terrace
★★★★ 3.8 (66 reviews)
Mentions washersSaturday hours
Appliance Repair
Dick Kearsley Service Center
520 State St, Clearfield, UT 84015
4.8 mi from Washington Terrace
★★★★½ 4.6 (609 reviews)
Saturday hours
Appliance Repair
Eagle Appliance Repair Of Salt Lake City
724 W 500 S #200, West Bountiful, UT 84087
20.0 mi from Washington Terrace
★★★★★ 5.0 (98 reviews)
Saturday hours
Appliance Repair
Ben Lomond Appliance Repair llc
190 E 3250 N, North Ogden, UT 84414
10.5 mi from Washington Terrace
★★★★★ 5.0 (155 reviews)
Saturday hours
Appliance Repair
Charlie Fuller's Appliance
530 W 1500 S Ste i, Woods Cross, UT 84087
20.7 mi from Washington Terrace
★★★★★ 4.8 (247 reviews)
Saturday hours
Appliance Repair
Baseline Home Maintenance
250 E 200 S #1600, Salt Lake City, UT 84111
28.3 mi from Washington Terrace
★★★★★ 5.0 (258 reviews)
Saturday hours
Appliance Repair
Ebenezer Appliance Repair
2850 Kiesel Ave, Ogden, UT 84401
3.1 mi from Washington Terrace
★★★★½ 4.7 (25 reviews)
Appliance Repair
Famous Appliance Service
501 900 N, North Salt Lake, UT 84054
21.6 mi from Washington Terrace
★★★★½ 4.7 (510 reviews)
Commercial
Appliance Repair
Precision Appliance Installs
314 N 650 E, Kaysville, UT 84037
9.3 mi from Washington Terrace
★★★★★ 5.0 (38 reviews)
Appliance Repair
Appliance Clinic Inc
37 W 250 N, Clearfield, UT 84015
4.4 mi from Washington Terrace
★★★★½ 4.5 (43 reviews)
Appliance Repair
Western Appliance Solution
50 W Broadway #333, Salt Lake City, UT 84101
28.3 mi from Washington Terrace
★★★★★ 5.0 (82 reviews)

Companies are shown by relevance and distance from Washington Terrace. A mention does not mean manufacturer certification, so ask each company about its experience with your washer.

Repair market snapshot: Washington Terrace, UT
With 4.5+ stars and at least 10 reviews13
Appliance repair companies in range (30 mi)40
Mention washer work1
Distance to the three closest (mi)1.6, 2.0, 3.1
Listing Saturday hours27
Mention a major washer brand1

First up for Washington Terrace: iFiX, LLC (2.0 miles away, based in Riverdale, 4.9 stars from 436 reviews); Sears Home Services Appliance Repair (29.9 miles away, based in Salt Lake City, 3.8 stars from 66 reviews, lists Saturday hours); Dick Kearsley Service Center (4.8 miles away, based in Clearfield, 4.6 stars from 609 reviews, lists Saturday hours); Eagle Appliance Repair Of Salt Lake City (20.0 miles away, based in West Bountiful, 5.0 stars from 98 reviews, lists Saturday hours).

⚡ Get connected with a washer technician near Washington Terrace
☎(866) 293-4411

When to Call for Washer Repair

  • Water left in the drum after the cycle
  • Washer will not start or the lid or door stays locked
  • Burning smell or a motor that hums without turning
  • Loud banging, shaking or walking during the spin

Why Washing Machines Break Down

Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Hoses, seals and the door bootFill hoses age and crack, drain hose clamps loosen, and the rubber door boot on a front loader can tear or trap water. Leaks usually start small under the washer before they show on the floor.

What a Washing Machine Technician Checks

Door boot and leaksOn front loaders the rubber door boot can tear or hold water and debris. A technician follows any leak back to its source, which may be the boot, a hose clamp, the pump, the inlet valve or the tub.
Suspension and shocksShock absorbers, dampers or suspension rods keep the tub from slamming during the spin. Worn parts cause banging, off-balance shutdowns and a washer that walks across the floor.
Drain pump and filterIf water stays in the drum, the technician checks the drain path first. Most front loaders have a pump filter behind a small panel at the bottom front, and many top loaders hide a pump that can jam on a sock or coin. The pump is then tested for power and blockage.

Troubleshooting first? Start with washer not filling with water or front-load vs top-load washer problems.

Before Anyone Touches the Washer

Whirlpool recommends replacing washer fill hoses every five years to lower the risk of a hose failing and leaking. Source: Whirlpool - Washing Machine Fill Hoses

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

Do not make an airtight seal between the drain hose and the standpipe or restrict the hose; standpipe height limits vary by model (Maytag's high-efficiency guide allows 18 to 96 inches). Source: Maytag - High-Efficiency Washer Installation Instructions

More: where washer leaks come from.

What Washer Repair Costs in Washington Terrace

Before replacing a washer in Washington Terrace, price the repair. Here is what published cost guides report for common jobs:

Replacement tends to make more financial sense once a repair runs past half the cost of buying and installing a new washer. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

What Washington Terrace Owners Should Know

Most washer calls in Washington Terrace come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308

In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.

Questions to Ask a Washington Terrace Washer Technician

  • What guarantee do you give on parts and labor?
  • Is your company licensed where my state requires it, and insured?
  • Do you work on front-load and top-load washers, or only one type?

Washing Machine Repair FAQs: Washington Terrace, UT

Why is my washer so loud on the spin cycle?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.
Why is my washer leaking?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.
Why does my front-load washer smell?
Residue from detergent and fabric softener collects in the door boot, the dispenser and the drum. Wipe the boot, clean the dispenser, run the washer's cleaning cycle or a hot empty cycle, and leave the door open between loads.
Why won't my washer drain?
The usual causes are a clogged drain pump filter (on most front loaders), a kinked or blocked drain hose, a sock or small item caught in the pump, or a failed drain pump. Clear the filter and check the hose first. If water still sits in the drum, a technician can test the pump.

Washer Repair by Brand in Washington Terrace

Washing Machine Repair Near Washington Terrace

A clear drain filter, open supply valves and the model number in hand make any washer repair in Washington Terrace faster and cheaper.

Tell us what your washer is doing and we will connect you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech