Serving Sunset, Utah and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Sunset, UT

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve Sunset.

Water sitting in the washer in Sunset?
Call our helpline to be connected with an independent washing machine technician near you.
☎(866) 293-4411
✓12 companies listed for Sunset✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. We pull these listings from public business data, remove closed businesses, parts stores and unrelated trades, and put companies that mention washers at the top.

Local Washing Machine Repair in Sunset, UT

Within 30 miles of Sunset there are 40 appliance repair companies in our data. The rest are spread across Salt Lake City (15), Clearfield (3), and Ogden (3). Distances run up to about 28 miles. Nearest on the list: Eagle Appliance Repair, around 1.5 miles out. Of those, 1 mentions washing machine or washer work by name. Across 29 rated companies, the average public rating is 4.5 stars.

Washer & Dryer Repair
Quality Appliance Service
2258 Constitution Blvd, West Valley City, UT 84119
29.1 mi from Sunset
★★★★½ 4.6 (1,441 reviews)
Mentions washers
Appliance Repair
iFiX, LLC
5187 1500 W #1, Riverdale, UT 84405
2.2 mi from Sunset
★★★★★ 4.9 (436 reviews)
Washer & Dryer Repair
Sears Home Services Appliance Repair
1338 Jefferson St, Salt Lake City, UT 84115
28.4 mi from Sunset
★★★★ 3.8 (66 reviews)
Mentions washersSaturday hours
Appliance Repair
Dick Kearsley Service Center
520 State St, Clearfield, UT 84015
2.3 mi from Sunset
★★★★½ 4.6 (609 reviews)
Saturday hours
Appliance Repair
Eagle Appliance Repair Of Salt Lake City
724 W 500 S #200, West Bountiful, UT 84087
18.8 mi from Sunset
★★★★★ 5.0 (98 reviews)
Saturday hours
Appliance Repair
Charlie Fuller's Appliance
530 W 1500 S Ste i, Woods Cross, UT 84087
19.6 mi from Sunset
★★★★★ 4.8 (247 reviews)
Saturday hours
Appliance Repair
Baseline Home Maintenance
250 E 200 S #1600, Salt Lake City, UT 84111
27.0 mi from Sunset
★★★★★ 5.0 (258 reviews)
Saturday hours
Appliance Repair
Ben Lomond Appliance Repair llc
190 E 3250 N, North Ogden, UT 84414
12.8 mi from Sunset
★★★★★ 5.0 (155 reviews)
Saturday hours
Appliance Repair
Famous Appliance Service
501 900 N, North Salt Lake, UT 84054
20.2 mi from Sunset
★★★★½ 4.7 (510 reviews)
Commercial
Appliance Repair
Appliance Clinic Inc
37 W 250 N, Clearfield, UT 84015
1.5 mi from Sunset
★★★★½ 4.5 (43 reviews)
Appliance Repair
Precision Appliance Installs
314 N 650 E, Kaysville, UT 84037
8.8 mi from Sunset
★★★★★ 5.0 (38 reviews)
Appliance Repair
Eagle Appliance Repair
113 W 250 N, Clearfield, UT 84015
1.5 mi from Sunset
★★★★ 4.2 (69 reviews)

We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.

Sunset repair companies in numbers
Distance to the three closest (mi)1.5, 1.5, 1.8
Companies within 30 miles47
Name washers or washing machines in their listing2
Open on Saturdays (per listing)31
Mention a major washer brand1
With 4.5+ stars and at least 10 reviews14

Closest matches for Sunset: Quality Appliance Service (29.1 miles away, based in West Valley City, 4.6 stars from 1,441 reviews); iFiX, LLC (2.2 miles away, based in Riverdale, 4.9 stars from 436 reviews); Sears Home Services Appliance Repair (28.4 miles away, based in Salt Lake City, 3.8 stars from 66 reviews, lists Saturday hours); Dick Kearsley Service Center (2.3 miles away, based in Clearfield, 4.6 stars from 609 reviews, lists Saturday hours).

⚡ Tell us what your washer is doing and we will connect you
☎(866) 293-4411

Washer Problems Worth a Service Call

  • Burning smell or a motor that hums without turning
  • An error code on the display
  • Grinding or roaring noise that rises with spin speed
  • Water on the floor under or in front of the washer

What Usually Goes Wrong

Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.
Drain pumps and filtersSocks, coins, hair ties and lint end up in the drain path. On most front loaders a small filter behind a panel at the bottom front catches them, and a clogged filter or jammed pump is behind many not-draining calls.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.

What a Washing Machine Technician Checks

Water level sensingA pressure switch or sensor tells the control how much water is in the tub. A blocked air tube or failed switch can cause overfilling, underfilling or a washer that will not move on to the next step.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Drain hose and standpipeThe drain hose runs to a standpipe or laundry sink. A kinked hose, a clog in the standpipe or a hose pushed too far down the pipe can stop draining or siphon water out mid-fill.

Troubleshooting first? Start with washer not filling with water or washer not draining.

Leaks and Safe Shutoff

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

To prevent siphoning, Whirlpool's instructions limit the drain hose to no more than 8 inches inside a standpipe that is at least 2 inches across and 39 to 96 inches tall, measured from the bottom of the washer. Source: Whirlpool - Washer Installation Instructions

More: where washer leaks come from.

Washing Machine Repair Cost Ranges

Before replacing a washer in Sunset, price the repair. Here is what published cost guides report for common jobs:

For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Around Sunset

Most washer calls in Sunset come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Utah has no contractor classification for appliance repair, but under the Construction Trades Licensing Act anyone who installs, repairs or replaces a residential or commercial gas appliance must hold natural gas technician certification, even on jobs otherwise too small to need a contractor license. Source: Utah Legislature H.B. 49 (2004), Natural Gas Technician Certification, amending Utah Code 58-55-305 and 58-55-308

In Utah, you can check a license with the Utah Licensee Lookup and Verification (Verify a License) or report a problem to the Utah Department of Commerce, Division of Consumer Protection.

Questions to Ask a Sunset Washer Technician

  • What guarantee do you give on parts and labor?
  • If the washer is leaking, will you find where the water starts before quoting a part?
  • What is the service call or diagnostic fee, and is it applied to the repair?

Washing Machine Repair FAQs: Sunset, UT

Why does my washer shake or walk across the floor?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.
Is the helpline a manufacturer?
No. We are an independent directory and are not affiliated with any appliance manufacturer. Our helpline connects you with a participating independent technician. If your washer is still under manufacturer coverage, contact the brand first.
Do you cover Sunset and nearby towns?
The companies on this page are within driving distance of Sunset. Each one sets its own service area, so check the distance shown and confirm your address when you call.

Washer Repair by Brand in Sunset

More Washing Machine Repair Pages Nearby

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a Sunset technician a trip for parts.

Get connected with a washer technician near Sunset
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech