Serving Taylor, Texas and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Taylor, TX

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve Taylor.

Talk to a washing machine tech near Taylor
Call our helpline to be connected with an independent washing machine technician near you.
☎(866) 293-4411
✓12 companies listed for Taylor✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. The Taylor list below starts with companies that show washer work in their listings, followed by other appliance repair companies nearby.

Local Washing Machine Repair in Taylor, TX

We found 40 appliance repair companies within 30 miles of Taylor. 3 of them are based in Taylor itself, and the rest are spread across Round Rock (14), Georgetown (9), and Pflugerville (7). The farthest listed company is about 19 miles out. 11 list washing machine or washer work specifically. Nearest on the list: Santana's Appliance LLC, around 0.5 miles out. Across 35 rated companies, the average public rating is 4.6 stars.

Washer & Dryer Repair
Santana's Appliance LLC
602 W 12th St, Taylor, TX 76574
0.5 mi from Taylor
★★★★½ 4.6 (369 reviews)
Mentions washers
Washer & Dryer Repair
Mr. Appliance of Austin
4701 Priem Ln #2A, Pflugerville, TX 78660
11.2 mi from Taylor
★★★★½ 4.7 (1,377 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Appliance Express
104 Parkview Dr, Georgetown, TX 78626
15.7 mi from Taylor
★★★★★ 4.8 (4,508 reviews)
Mentions washers
Washer & Dryer Repair
PMA Home Experts
17100 Gibbons Path, Round Rock, TX 78664
15.7 mi from Taylor
★★★★★ 5.0 (27 reviews)
Mentions washers
Washer & Dryer Repair
The Appliance Family
13000 N Interstate Hwy 35 SET 12-212, Austin, TX 78753
18.7 mi from Taylor
★★★★★ 4.8 (198 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
True Family Appliance Solutions
3524 Soft Shore Ln, Pflugerville, TX 78660
12.2 mi from Taylor
★★★★★ 4.8 (24 reviews)
Mentions washers
Washer & Dryer Repair
The Appliance Family
2120 N Mays St Ste 650, Round Rock, TX 78664
16.1 mi from Taylor
★★★★½ 4.6 (17 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Munko Appliance Repair
8110 Miller Falls Dr, Round Rock, TX 78681
18.2 mi from Taylor
★★★★★ 5.0 (50 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
12625 N Interstate Hwy 35, Austin, TX 78753
18.7 mi from Taylor
★★★★ 4.2 (156 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
2121 N Main St, Taylor, TX 76574
1.2 mi from Taylor
★★★★ 4.1 (48 reviews)
Mentions washersSaturday hours
Appliance Repair
Reliable Hutto Appliance Repair
329 Ed Schmidt Blvd, Hutto, TX 78634
8.5 mi from Taylor
★★★★★ 5.0 (2 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
900 N Austin Ave #123, Georgetown, TX 78626
16.0 mi from Taylor
★★★★ 4.2 (92 reviews)
Mentions washersSaturday hours

Companies are shown by relevance and distance from Taylor. A mention does not mean manufacturer certification, so ask each company about its experience with your washer.

By the numbers: technicians near Taylor
Distance to the three closest (mi)0.5, 1.2, 4.8
Repair companies inside 30 miles60
Mention a major washer brand0
Name washers or washing machines in their listing13
Open on Saturdays (per listing)44
With 4.5+ stars and at least 10 reviews25

Closest matches for Taylor: Santana's Appliance LLC (0.5 miles away, 4.6 stars from 369 reviews); Mr. Appliance of Austin (11.2 miles away, based in Pflugerville, 4.7 stars from 1,377 reviews, lists Saturday hours); Appliance Express (15.7 miles away, based in Georgetown, 4.8 stars from 4,508 reviews); PMA Home Experts (15.7 miles away, based in Round Rock, 5.0 stars from 27 reviews).

⚡ Tell us what your washer is doing and we will connect you
☎(866) 293-4411

When to Call for Washer Repair

  • Musty or mildew smell from the drum or door seal
  • Washer will not start or the lid or door stays locked
  • Burning smell or a motor that hums without turning
  • An error code on the display

The Usual Washer Culprits in Taylor

Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Drain pumps and filtersSocks, coins, hair ties and lint end up in the drain path. On most front loaders a small filter behind a panel at the bottom front catches them, and a clogged filter or jammed pump is behind many not-draining calls.
Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.

How a Washer Service Call Usually Goes in Taylor

Suspension and shocksShock absorbers, dampers or suspension rods keep the tub from slamming during the spin. Worn parts cause banging, off-balance shutdowns and a washer that walks across the floor.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Lid switch or door lockTop loaders use a lid switch or lid lock and front loaders use a door lock. If the control cannot confirm the lid or door is shut and locked, the washer will not fill, agitate or spin, and a technician tests the switch and its wiring.

Troubleshooting first? Start with washer not draining or washer not filling with water.

Leaks and Safe Shutoff

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Unplug the washer before servicing or cleaning it; pressing the power button does not disconnect it from the electrical supply. Source: GE Appliances - Washer Owner's Manual

More: where washer leaks come from.

Repair or Replace Your Washer?

A washer repair is usually a single part plus labor. Reference ranges from published cost guides:

For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Local Notes for Taylor

Most washer calls in Taylor come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Texas has no separate appliance repair license; under the Plumbing License Law, appliance dealers and their employees may install and service appliances (other than water heaters) without a plumbing license when hooking up to existing openings with a code-approved appliance connector, while other gas or water piping work generally requires a plumbing license. Source: Plumbing License Law, Tex. Occ. Code ch. 1301, ยง1301.053 (Texas State Board of Plumbing Examiners)

In Texas, you can check a license with the Texas plumbing Public License Search or report a problem to the Texas Attorney General, Consumer Protection Division.

Before You Book in Taylor

  • Is your company licensed where my state requires it, and insured?
  • Can you give a written estimate before ordering parts?
  • If a part has to be ordered, how soon can you come back to finish?

Washing Machine Repair FAQs: Taylor, TX

Why does my washer shake or walk across the floor?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.
Why is my washer leaking?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.
What stops a washer from spinning?
An unbalanced load, water that will not drain, or a lid switch or door lock that is not engaging stops most spin cycles. If those check out, a technician looks at the drive belt, motor coupling, motor and control.
Why won't my washer drain?
The usual causes are a clogged drain pump filter (on most front loaders), a kinked or blocked drain hose, a sock or small item caught in the pump, or a failed drain pump. Clear the filter and check the hose first. If water still sits in the drum, a technician can test the pump.

Washer Repair by Brand in Taylor

More Washing Machine Repair Pages Nearby

Before you call a Taylor technician, check that the washer is plugged in, the hot and cold valves behind it are open and the drain hose is not kinked. If it is a front loader, clean the drain pump filter. If the problem stays, have the model number ready.

One call to reach a local washing machine repair company
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech