Serving Rapid City, South Dakota and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Rapid City, SD

A local list of washer repair companies near Rapid City, SD, sorted by how closely they match the work, then by distance and public ratings.

Need washer repair in Rapid City?
One call connects you with a local technician who repairs front-load and top-load washers.
☎(866) 293-4411
✓8 companies listed for Rapid City✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. This page lists independent appliance repair companies serving Rapid City and the Pennington County area, with companies that mention washer work shown first.

Washer Technicians Serving Rapid City, SD

Within 60 miles of Rapid City there are 8 appliance repair companies in our data. 5 list an address in Rapid City, and other nearby bases include Spearfish (2) and Hot Springs (1). Distances run up to about 46 miles. 3 of them mention washing machine or washer work in their listing or website. Sears Appliance Repair is the nearest, roughly 1.7 miles from Rapid City. Rated companies nearby average 4.8 stars across 6 businesses. Rapid City is a smaller market, so expect a longer drive and ask whether a trip charge applies.

Washer & Dryer Repair
Appliance Repair Services
3620 Redwood St, Rapid City, SD 57701
1.7 mi from Rapid City
★★★★★ 4.9 (279 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
1111 E North St, Rapid City, SD 57701
1.7 mi from Rapid City
Mentions washersSaturday hours
Appliance Repair
K&D Appliance Service
3405 Edwards St, Rapid City, SD 57703
3.5 mi from Rapid City
★★★★★ 4.8 (1,304 reviews)
Washer & Dryer Repair
Sears Appliance Repair
137 E Illinois St, Spearfish, SD 57783
42.8 mi from Rapid City
Mentions washersSaturday hours
Appliance Repair
Appliances & Electronics Repair Lab
901 Gainsboro Dr, Rapid City, SD 57701
4.2 mi from Rapid City
★★★★½ 4.7 (50 reviews)
Saturday hours
Appliance Repair
Brink Inc. Hobart Sales & Service
1212 Oregon St, Rapid City, SD 57701
1.8 mi from Rapid City
★★★★½ 4.4 (5 reviews)
Appliance Repair
T & W Appliance LLC
947 E Colorado Blvd, Spearfish, SD 57783
41.9 mi from Rapid City
★★★★½ 4.7 (28 reviews)
Appliance Repair
Bennett's Appliance Services
306 N 4th St, Hot Springs, SD 57747
45.8 mi from Rapid City
★★★★★ 5.0 (1 review)

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

Repair market snapshot: Rapid City, SD
Mention washer work3
Repair companies inside 60 miles8
Mention a major washer brand0
Three nearest companies, miles away1.7, 1.7, 1.8
With 4.5+ stars and at least 10 reviews4
Open on Saturdays (per listing)3

At the top of the Rapid City list: Appliance Repair Services (1.7 miles away, 4.9 stars from 279 reviews); Sears Appliance Repair (1.7 miles away, lists Saturday hours); K&D Appliance Service (3.5 miles away, 4.8 stars from 1,304 reviews); Sears Appliance Repair (42.8 miles away, based in Spearfish, lists Saturday hours).

⚡ Skip the calling around: we will find a washer tech for you
☎(866) 293-4411

Washer Problems Worth a Service Call

  • Loud banging, shaking or walking during the spin
  • Burning smell or a motor that hums without turning
  • An error code on the display
  • Washer will not start or the lid or door stays locked

The Usual Washer Culprits in Rapid City

Drain pumps and filtersSocks, coins, hair ties and lint end up in the drain path. On most front loaders a small filter behind a panel at the bottom front catches them, and a clogged filter or jammed pump is behind many not-draining calls.
Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.

Inside a Washer Repair Visit

Water level sensingA pressure switch or sensor tells the control how much water is in the tub. A blocked air tube or failed switch can cause overfilling, underfilling or a washer that will not move on to the next step.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Door boot and leaksOn front loaders the rubber door boot can tear or hold water and debris. A technician follows any leak back to its source, which may be the boot, a hose clamp, the pump, the inlet valve or the tub.

Troubleshooting first? Start with washer not spinning or washer smells like mildew.

If Your Washer Is Leaking

Closing the washer's water faucets when the machine is not in use takes pressure off the hoses and valves and limits flooding if a hose gives way. Source: GE Appliances - Washer Owner's Manual

Unplug the washer before servicing or cleaning it; pressing the power button does not disconnect it from the electrical supply. Source: GE Appliances - Washer Owner's Manual

More: where washer leaks come from.

Repair or Replace Your Washer?

A washer repair is usually a single part plus labor. Reference ranges from published cost guides:

50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Around Rapid City

Most washer calls in Rapid City come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

The South Dakota Plumbing Commission issues Appliance Contractor and Appliance Installer licenses as plumbing specialty licenses; official pages reviewed did not spell out which appliance work they cover or whether repair alone requires one. Source: South Dakota Plumbing Commission - Licensing

In South Dakota, you can check a license with the South Dakota Plumbing Commission lists of licensees (specialty licensees, including appliance) or report a problem to the South Dakota Attorney General, Division of Consumer Protection.

How to Choose a Washing Machine Technician Near Rapid City

  • What is the service call or diagnostic fee, and is it applied to the repair?
  • If the washer is leaking, will you find where the water starts before quoting a part?
  • What guarantee do you give on parts and labor?

Washing Machine Repair FAQs: Rapid City, SD

Do you cover Rapid City and nearby towns?
The companies on this page are within driving distance of Rapid City. Each one sets its own service area, so check the distance shown and confirm your address when you call.
Why is my washer leaking?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.
Why won't my washer spin?
An unbalanced load, water that will not drain, or a lid switch or door lock that is not engaging stops most spin cycles. If those check out, a technician looks at the drive belt, motor coupling, motor and control.
Why is there water left in my washer?
The usual causes are a clogged drain pump filter (on most front loaders), a kinked or blocked drain hose, a sock or small item caught in the pump, or a failed drain pump. Clear the filter and check the hose first. If water still sits in the drum, a technician can test the pump.

Washer Repair by Brand in Rapid City

Washing Machine Repair in Nearby Cities

Before you call a Rapid City technician, check that the washer is plugged in, the hot and cold valves behind it are open and the drain hose is not kinked. If it is a front loader, clean the drain pump filter. If the problem stays, have the model number ready.

Tell us what your washer is doing and we will connect you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech