Serving Highlands, Texas and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Highlands, TX

Washing machine repair from independent technicians serving Highlands, with ratings, distances and what to check before you call.

Need washer repair in Highlands?
Call our helpline to be connected with an independent washing machine technician near you.
☎(866) 293-4411
✓12 companies listed for Highlands✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. This page lists independent appliance repair companies serving Highlands and the Harris County area, with companies that mention washer work shown first.

Washer Technicians Serving Highlands, TX

Within 30 miles of Highlands there are 40 appliance repair companies in our data. The rest are spread across Pasadena (15), Baytown (7), and Houston (6). Nearest on the list: Operation: Save Appliance, around 4.1 miles out. 11 list washing machine or washer work specifically. Across 33 rated companies, the average public rating is 4.5 stars.

Washer & Dryer Repair
Quality Repairs
18702 Tranquility Dr, Humble, TX 77346
13.6 mi from Highlands
★★★★★ 4.9 (554 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Operation: Save Appliance
5124 Parsley Ave, Baytown, TX 77521
4.1 mi from Highlands
★★★★★ 5.0 (74 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
1000 San Jacinto Mall, Baytown, TX 77521
4.5 mi from Highlands
★★★★½ 4.6 (187 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Mr. Appliance of Baytown
606 Rollingbrook Dr Ste 2M, Baytown, TX 77521
6.4 mi from Highlands
★★★★★ 4.9 (104 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Superior Appliances Repair
2501 Preston Ave Suite#2507, Pasadena, TX 77503
11.7 mi from Highlands
★★★★★ 4.9 (81 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
999 Pasadena Blvd, Pasadena, TX 77506
11.8 mi from Highlands
★★★★½ 4.5 (271 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Cannon Appliance Repair
707 Lindenwood Dr, Baytown, TX 77520
7.1 mi from Highlands
★★★★★ 5.0 (50 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Mr. Appliance of Deer Park
3222 Burke Rd Ste 209E, Pasadena, TX 77504
13.0 mi from Highlands
★★★★★ 4.8 (190 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
6793 Spencer Hwy, Pasadena, TX 77505
11.2 mi from Highlands
★★★★½ 4.5 (31 reviews)
Mentions washersSaturday hours
Appliance Repair
Perry's Appliance Repair
2918 N Main St, Baytown, TX 77521
6.9 mi from Highlands
★★★★ 3.8 (91 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
5932 Fairmont Pkwy, Pasadena, TX 77505
12.6 mi from Highlands
★★★★½ 4.4 (85 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Appliance Repair Guy
1800 Dolphin Dr, Seabrook, TX 73344
16.9 mi from Highlands
★★★★ 4.2 (58 reviews)
Mentions washers

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

Highlands repair companies in numbers
Listing Saturday hours41
Mention washer work15
Companies within 30 miles60
Rated 4.5 stars or higher (10+ reviews)21
Three nearest companies, miles away4.1, 4.4, 4.4
Mention a major washer brand0

Closest matches for Highlands: Quality Repairs (13.6 miles away, based in Humble, 4.9 stars from 554 reviews, lists Saturday hours); Operation: Save Appliance (4.1 miles away, based in Baytown, 5.0 stars from 74 reviews, lists Saturday hours); Sears Appliance Repair (4.5 miles away, based in Baytown, 4.6 stars from 187 reviews, lists Saturday hours); Mr. Appliance of Baytown (6.4 miles away, based in Baytown, 4.9 stars from 104 reviews, lists Saturday hours).

⚡ Tell us what your washer is doing and we will connect you
☎(866) 293-4411

Signs Your Washing Machine Needs a Technician

  • Washer will not start or the lid or door stays locked
  • An error code on the display
  • Washer will not spin, or clothes come out soaking wet
  • Washer fills slowly, will not fill, or keeps filling

What Usually Goes Wrong

Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.
Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.

Inside a Washer Repair Visit

Water inlet valve and hosesAn electric valve meters hot and cold water in. A technician checks its inlet screens for sediment and tests its coils when the washer fills slowly, will not fill, or will not stop filling.
Suspension and shocksShock absorbers, dampers or suspension rods keep the tub from slamming during the spin. Worn parts cause banging, off-balance shutdowns and a washer that walks across the floor.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.

Troubleshooting first? Start with washer not draining or washer not filling with water.

Before Anyone Touches the Washer

Closing the washer's water faucets when the machine is not in use takes pressure off the hoses and valves and limits flooding if a hose gives way. Source: GE Appliances - Washer Owner's Manual

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

Do not make an airtight seal between the drain hose and the standpipe or restrict the hose; standpipe height limits vary by model (Maytag's high-efficiency guide allows 18 to 96 inches). Source: Maytag - High-Efficiency Washer Installation Instructions

More: where washer leaks come from.

Washing Machine Repair Cost Ranges

Most washing machine repairs come down to one part and an hour or two of labor, which is why many are worth pricing before you shop for a new washer. Published ranges:

Replacement tends to make more financial sense once a repair runs past half the cost of buying and installing a new washer. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Laundry Notes for Highlands, TX

Most washer calls in Highlands come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Texas has no separate appliance repair license; under the Plumbing License Law, appliance dealers and their employees may install and service appliances (other than water heaters) without a plumbing license when hooking up to existing openings with a code-approved appliance connector, while other gas or water piping work generally requires a plumbing license. Source: Plumbing License Law, Tex. Occ. Code ch. 1301, ยง1301.053 (Texas State Board of Plumbing Examiners)

In Texas, you can check a license with the Texas plumbing Public License Search or report a problem to the Texas Attorney General, Consumer Protection Division.

How to Choose a Washing Machine Technician Near Highlands

  • If a part has to be ordered, how soon can you come back to finish?
  • Will you check the drain pump filter and drain hose before replacing the pump?
  • If the washer is leaking, will you find where the water starts before quoting a part?

Washing Machine Repair FAQs: Highlands, TX

What should I check before calling?
Make sure the washer is plugged in and the outlet works, the lid or door closes fully, and both water valves are open. If the washer is leaking, unplug it and turn off both supply valves before doing anything else.
Do you cover Highlands and nearby towns?
The companies on this page are within driving distance of Highlands. Each one sets its own service area, so check the distance shown and confirm your address when you call.
Why is there water left in my washer?
The usual causes are a clogged drain pump filter (on most front loaders), a kinked or blocked drain hose, a sock or small item caught in the pump, or a failed drain pump. Clear the filter and check the hose first. If water still sits in the drum, a technician can test the pump.
Why is my washer so loud on the spin cycle?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.

Washer Repair by Brand in Highlands

More Washing Machine Repair Pages Nearby

Before you call a Highlands technician, check that the washer is plugged in, the hot and cold valves behind it are open and the drain hose is not kinked. If it is a front loader, clean the drain pump filter. If the problem stays, have the model number ready.

Get connected with a washer technician near Highlands
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech