Serving Pulaski, Tennessee and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Pulaski, TN

A local list of washer repair companies near Pulaski, TN, sorted by how closely they match the work, then by distance and public ratings.

Washer down in Pulaski?
One call connects you with a local technician who repairs front-load and top-load washers.
☎(866) 293-4411
✓12 companies listed for Pulaski✓Independent, not a manufacturer✓Public ratings & distances

When a washer quits in Pulaski, the first question is whether it is a clog or a setting you can clear yourself or a failed part, and that decides whether you need a technician at all. We pull these listings from public business data, remove closed businesses, parts stores and unrelated trades, and put companies that mention washers at the top.

Local Washing Machine Repair in Pulaski, TN

17 repair companies serve Pulaski from within 30 miles. 1 list an address in Pulaski, and other nearby bases include Athens (4), Ardmore (2), and Fayetteville (2). Distances run up to about 28 miles. 7 list washing machine or washer work specifically. Nearest on the list: Easy Pay Store, around 0.5 miles out. Across 16 rated companies, the average public rating is 4.4 stars.

Washer & Dryer Repair
Sears Appliance Repair
1604 N Locust Ave B B, Lawrenceburg, TN 38464
16.9 mi from Pulaski
★★★★½ 4.6 (34 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
A & A Appliance and HVAC, LLC.
3220 Charity Ln, Hazel Green, AL 35750
25.4 mi from Pulaski
★★★★★ 4.8 (163 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Dr. Dan's Appliance Service
26555 Main St, Ardmore, TN 38449
17.5 mi from Pulaski
★★★★½ 4.7 (213 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
104 US-31, Athens, AL 35611
27.3 mi from Pulaski
★★★★ 4.2 (61 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Ace Appliance Parts & Services
3 Tom Carroll Rd, Summertown, TN 38483
28.0 mi from Pulaski
★★★★★ 4.8 (5 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
1406 Huntsville Hwy, Fayetteville, TN 37334
26.9 mi from Pulaski
★★★★½ 4.4 (39 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Jay's Appliance Repair
1027 US Hwy 72 E, Athens, AL 35611
28.5 mi from Pulaski
★★★★ 4.2 (87 reviews)
Mentions washers
Appliance Repair
Easy Pay Store
212 E Madison St A, Pulaski, TN 38478
0.5 mi from Pulaski
★★★★½ 4.6 (40 reviews)
Saturday hours
Appliance Repair
Gilliam Appliance Repair Service
4936 Miller Lake Rd, Culleoka, TN 38451
19.4 mi from Pulaski
★★★★½ 4.4 (27 reviews)
Appliance Repair
A Able Appliance Repair
565 Molino Rd, Fayetteville, TN 37334
22.2 mi from Pulaski
★★★★½ 4.4 (25 reviews)
Appliance Repair
Partners Appliance Repair Masters
26410 Main St, Ardmore, TN 38449
17.4 mi from Pulaski
★★★★★ 5.0 (4 reviews)
Appliance Repair
Eddie Electric
1100 Springplace Rd, Lewisburg, TN 37091
22.2 mi from Pulaski
★★★★½ 4.5 (8 reviews)
Saturday hours

Companies are shown by relevance and distance from Pulaski. A mention does not mean manufacturer certification, so ask each company about its experience with your washer.

By the numbers: technicians near Pulaski
Rated 4.5 stars or higher (10+ reviews)4
Appliance repair companies in range (30 mi)17
Mention a major washer brand0
Listing Saturday hours8
Name washers or washing machines in their listing7
Three nearest companies, miles away0.5, 16.2, 16.9

At the top of the Pulaski list: Sears Appliance Repair (16.9 miles away, based in Lawrenceburg, 4.6 stars from 34 reviews, lists Saturday hours); A & A Appliance and HVAC, LLC. (25.4 miles away, based in Hazel Green, 4.8 stars from 163 reviews, lists Saturday hours); Dr. Dan's Appliance Service (17.5 miles away, based in Ardmore, 4.7 stars from 213 reviews); Sears Appliance Repair (27.3 miles away, based in Athens, 4.2 stars from 61 reviews, lists Saturday hours).

⚡ Get connected with a washer technician near Pulaski
☎(866) 293-4411

When to Call for Washer Repair

  • Loud banging, shaking or walking during the spin
  • Washer will not start or the lid or door stays locked
  • An error code on the display
  • Water left in the drum after the cycle

What Usually Goes Wrong

Drain pumps and filtersSocks, coins, hair ties and lint end up in the drain path. On most front loaders a small filter behind a panel at the bottom front catches them, and a clogged filter or jammed pump is behind many not-draining calls.
Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.
Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.

What Gets Fixed on a Pulaski Washer Call

Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Water level sensingA pressure switch or sensor tells the control how much water is in the tub. A blocked air tube or failed switch can cause overfilling, underfilling or a washer that will not move on to the next step.
Tub bearings and sealA rumble or roar that gets louder as the drum speeds up usually means worn bearings, often after a tub seal has let water reach them. It is one of the bigger repairs, so the technician will compare it with the washer's age and value.

Troubleshooting first? Start with washer not filling with water or washer smells like mildew.

Before Anyone Touches the Washer

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

To prevent siphoning, Whirlpool's instructions limit the drain hose to no more than 8 inches inside a standpipe that is at least 2 inches across and 39 to 96 inches tall, measured from the bottom of the washer. Source: Whirlpool - Washer Installation Instructions

More: where washer leaks come from.

What Washer Repair Costs in Pulaski

A washer repair is usually a single part plus labor. Reference ranges from published cost guides:

Replacement tends to make more financial sense once a repair runs past half the cost of buying and installing a new washer. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

What Pulaski Owners Should Know

Most washer calls in Pulaski come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Tennessee's Board for Licensing Contractors does not list an appliance repair license among the licenses it issues (general contractor, home improvement, limited licensed electrician and limited licensed plumber). Source: TN Board for Licensing Contractors

In Tennessee, you can check a license with the Tennessee Department of Commerce and Insurance: Verify a License or report a problem to the Tennessee Division of Consumer Affairs (Office of the Attorney General).

How to Choose a Washing Machine Technician Near Pulaski

  • What guarantee do you give on parts and labor?
  • If a part has to be ordered, how soon can you come back to finish?
  • Will you check the drain pump filter and drain hose before replacing the pump?

Washing Machine Repair FAQs: Pulaski, TN

Why is there water left in my washer?
The usual causes are a clogged drain pump filter (on most front loaders), a kinked or blocked drain hose, a sock or small item caught in the pump, or a failed drain pump. Clear the filter and check the hose first. If water still sits in the drum, a technician can test the pump.
What should I check before calling?
Make sure the washer is plugged in and the outlet works, the lid or door closes fully, and both water valves are open. If the washer is leaking, unplug it and turn off both supply valves before doing anything else.
Where is the water under my washer coming from?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.
How do I get rid of a washer mildew smell?
Residue from detergent and fabric softener collects in the door boot, the dispenser and the drum. Wipe the boot, clean the dispenser, run the washer's cleaning cycle or a hot empty cycle, and leave the door open between loads.

Find Your Washer Brand in Pulaski

Washing Machine Repair in Nearby Cities

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a Pulaski technician a trip for parts.

Tell us what your washer is doing and we will connect you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech