Most Maytag washer repairs in Connell involve the same few systems: the drain pump, the lid or door lock, the drive, the water supply and the controls. The Connell list starts with companies that name Maytag, followed by other appliance repair companies that work on washers.
Washing Machine Repair Near Me is independent and not affiliated with Maytag. Listed companies are independent technicians who repair Maytag washers and other brands.
Independent Maytag Washer Technicians, Connell WA
Within 60 miles of Connell there are 14 appliance repair companies in our data. Other nearby bases include Pasco (3), Kennewick (3), and Walla Walla (3). No company within 90 miles of Connell mentions Maytag by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Nearest on the list: VSG Appliances, around 31.8 miles out. Rated companies nearby average 4.3 stars across 14 businesses. Connell is a smaller market, so expect a longer drive and ask whether a trip charge applies.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Mention Maytag | 0 |
|---|---|
| Three nearest companies, miles away | 31.8, 32.0, 32.5 |
| Rated 4.5 stars or higher (10+ reviews) | 8 |
| Open on Saturdays (per listing) | 8 |
| Mention washer work | 3 |
| Repair companies inside 60 miles | 14 |
At the top of the Connell list: Fred's Appliance (36.3 miles away, based in Kennewick, 4.1 stars from 731 reviews, lists Saturday hours); Master's Appliance & Refrigeration, LLC (32.0 miles away, based in Pasco, 4.2 stars from 77 reviews); Sears Appliance Repair (38.3 miles away, based in Moses Lake, 3.9 stars from 98 reviews, lists Saturday hours); VSG Appliances (31.8 miles away, based in Pasco, 4.9 stars from 158 reviews, lists Saturday hours).
Maytag sells top-load agitator, top-load impeller, and front-load washers in the U.S., and the repair path differs by type: front loaders add a door lock, door boot and pump filter, while top loaders rely on a lid switch and either an agitator or an impeller.
Know Your Maytag Washer
How Maytag Washers Are Built
The washer will only run and spin when the lid or door switch senses it is fully closed, and the lid or door locks at the start of a cycle. Source: Maytag Product Help - Washer Not Draining or Spinning? Troubleshooting Guide
A liquid-filled balance ring at the top of the tub shifts to offset uneven loads so the basket stays steady at higher spin speeds. Source: Maytag Product Help - Water Heard in Washer, but not Seen - Balance Ring Information
Common Maytag Washer Problems
- Off balance, shaking or walking. Maytag says to spread the load evenly, confirm the shipping bolts were removed, and level the washer so all four feet sit firmly on the floor. Source: Maytag Product Help - Washer is Vibrating, Walking or Moving
- Lid or door won't lock. For lid or door lock codes, Maytag says to check for clothing or objects blocking the latch area and then reset the washer by unplugging it for five minutes. Source: Maytag Product Help - F5E2 - Error Code (top load)
Reading a Maytag Washer Error Code
| Code | What it means |
|---|---|
| F9E1 | Top load: long drain, usually tied to a kinked, clogged or improperly installed drain hose. Source: Maytag Product Help - F9E1 - Error Code |
| F5 E2 (front load) | Front load: the door is not locking properly; make sure it is fully latched and nothing is caught in it. Source: Maytag Product Help - F5 E2 - Error Code (front load) |
| F8E1 | Top load: the washer is not detecting the right amount of incoming water. Source: Maytag Product Help - F8E1 - Error Code |
Signs Your Maytag Washer Needs a Technician
- Loud banging, shaking or walking during the spin
- An error code on the display
- Washer fills slowly, will not fill, or keeps filling
Inside a Washer Repair Visit
Owner Care for Maytag Washers
- On front loaders, wipe and dry the door seal folds, remove wet loads promptly and leave the door slightly open after use to limit mildew and odor. Source: Maytag Product Help - Cleaning a Front Load Washer Door Seal
- Clean the front load drain pump filter every few months or as needed to clear lint and debris; check the owner's manual for its location on your model. Source: Maytag Product Help - Cleaning the Pump Filter - Front Load Washer
Brand guides: Maytag Washer Not Draining or Spinning: Causes.
Maytag Washer Repair Cost Ranges
Most Maytag washer repairs involve common parts and an hour or two of labor. For reference, published cost guides report:
- Agitator replacement: $350–$575 Source: Fixr - How much does it cost to repair a washing machine?
- Motor replacement: $300–$500 Source: Fixr - How much does it cost to repair a washing machine?
- Water level / pressure switch replacement: $100–$225 Source: Fixr - How much does it cost to repair a washing machine?
- Service call / diagnostic fee (often waived if you go ahead with the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?
Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.
Before the Technician Arrives
- Where the washer drains (standpipe or laundry sink)
- The brand, model and serial number from the label inside the lid, around the door opening or on the back of the cabinet
- What happens during the cycle (no start, no fill, no drain, no spin, leaks, noise)
What Connell Owners Should Know
Most washer calls in Connell come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.
Washington's Department of Labor & Industries issues an appliance repair (07D) specialty electrician certificate that covers like-for-like repair and replacement of self-contained appliances such as ovens on an unchanged circuit, but excludes branch-circuit wiring and plumbing work. Source: WAC 296-46B-920, Electrical/telecommunications license/certificate types and scope of work
In Washington, you can check a license with the L&I Verify a Contractor, Tradesperson or Business or report a problem to the Washington State Office of the Attorney General, Consumer Protection.
Hiring a Washer Repair Company in Connell
- Will you check the drain pump filter and drain hose before replacing the pump?
- If a part has to be ordered, how soon can you come back to finish?
- Do you work on front-load and top-load washers, or only one type?
Maytag Washer Repair FAQs: Connell, WA
What should I do about a Maytag error code?
Do you work for Maytag?
Is my Maytag washer worth repairing?
Other Washer Repair in Connell
Maytag Washer Repair in Nearby Cities
Before you call, find the model and serial number on your Maytag washer's label, usually inside the lid, around the door opening or on the back of the cabinet. A technician who knows the model can often tell you on the phone what the first visit will involve.