A Maytag washer shares most of its basic parts with other washers, but its drive design, lid or door lock, controls and error codes are specific to the brand. The Waterloo list starts with companies that name Maytag, followed by other appliance repair companies that work on washers.
Washing Machine Repair Near Me is independent and not affiliated with Maytag. Listed companies are independent technicians who repair Maytag washers and other brands.
Independent Maytag Washer Technicians, Waterloo IA
Our data shows 40 appliance repair companies inside a 60-mile radius of Waterloo. 4 list an address in Waterloo, and other nearby bases include Cedar Rapids (18), Marion (4), and Charles City (3). None of the repair companies near Waterloo name Maytag in their listings, so we show the closest appliance repair companies. Ask each one about your machine before booking. Checkmark Appliance Repair is the nearest, roughly 0.8 miles from Waterloo. The 39 rated companies in range average 4.7 stars. Waterloo is a smaller market, so expect a longer drive and ask whether a trip charge applies.
We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.
| Rated 4.5 stars or higher (10+ reviews) | 10 |
|---|---|
| Open on Saturdays (per listing) | 30 |
| Mention washer work | 7 |
| Companies within 60 miles | 41 |
| Three nearest companies, miles away | 0.8, 1.7, 2.0 |
| Mention Maytag | 0 |
First up for Waterloo: Sears Appliance Repair (2.6 miles away, 4.7 stars from 86 reviews, lists Saturday hours); Peoples Appliance Inc (1.7 miles away, 4.2 stars from 100 reviews, lists Saturday hours); Direct Appliance (3.8 miles away, based in Cedar Falls, 4.7 stars from 107 reviews, lists Saturday hours); Appliance Plus (25.7 miles away, based in Oelwein, 4.9 stars from 271 reviews, lists Saturday hours).
Know Your Maytag Washer
What a Maytag Washer Technician Deals With
The washer will only run and spin when the lid or door switch senses it is fully closed, and the lid or door locks at the start of a cycle. Source: Maytag Product Help - Washer Not Draining or Spinning? Troubleshooting Guide
A liquid-filled balance ring at the top of the tub shifts to offset uneven loads so the basket stays steady at higher spin speeds. Source: Maytag Product Help - Water Heard in Washer, but not Seen - Balance Ring Information
What Maytag Says to Check First
- Washer not draining or not spinning. Maytag says to confirm the lid or door is fully shut and the load is balanced, then check for oversudsing, a kinked or clogged drain hose, standpipe height and, on some front loaders, a clogged drain pump filter. Source: Maytag Product Help - Washer Not Draining or Spinning? Troubleshooting Guide
- Lid or door won't lock. For lid or door lock codes, Maytag says to check for clothing or objects blocking the latch area and then reset the washer by unplugging it for five minutes. Source: Maytag Product Help - F5E2 - Error Code (top load)
What Maytag Washer Codes Mean
| Code | What it means |
|---|---|
| F5E2 | Top load: the lid lock cannot engage, often because something is obstructing the lock area. Source: Maytag Product Help - F5E2 - Error Code |
| F8E1 | Top load: the washer is not detecting the right amount of incoming water. Source: Maytag Product Help - F8E1 - Error Code |
| F5E3 | Top load: lid lock problem; Maytag suggests a five-minute power reset first. Source: Maytag Product Help - F5E3 - Error Code |
When to Call for Maytag Washer Repair
- Washer fills slowly, will not fill, or keeps filling
- Burning smell or a motor that hums without turning
- Water left in the drum after the cycle
Inside a Washer Repair Visit
Care Maytag Recommends for Its Washers
- If fill is slow, shut off the water, remove the inlet hoses and scrub clogged inlet screens on the back of the water valve with a brush and mild soap. Source: Maytag Product Help - Checking the Fill Hoses if the Washer is not Filling
- Clean the front load drain pump filter every few months or as needed to clear lint and debris; check the owner's manual for its location on your model. Source: Maytag Product Help - Cleaning the Pump Filter - Front Load Washer
Brand guides: Maytag Washer Not Draining or Spinning: Causes.
Budgeting for a Maytag Washer Repair
A Maytag washer repair usually costs about the same as any other brand for the same part. Published ranges:
- Door lock replacement: $110–$200 Source: Fixr - How much does it cost to repair a washing machine?
- Tub / drum bearing replacement: $150–$225 Source: Fixr - How much does it cost to repair a washing machine?
- Shock absorber replacement: $150–$300 Source: Fixr - How much does it cost to repair a washing machine?
- Transmission replacement: $200–$350 Source: Fixr - How much does it cost to repair a washing machine?
- Typical washing machine repair: $150–$400 Source: Fixr - How much does it cost to repair a washing machine?
- After-hours / emergency visit surcharge: $100–$200 per visit Source: Fixr - How much does it cost to repair a washing machine?
For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?
Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.
What to Have Ready for a Maytag Washer Call
- How old the washer is
- Where the washer drains (standpipe or laundry sink)
- What happens during the cycle (no start, no fill, no drain, no spin, leaks, noise)
Local Notes for Waterloo
Most washer calls in Waterloo come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.
Iowa does not issue a general appliance repair technician license; the Plumbing and Mechanical Systems Board licenses plumbing, HVAC, refrigeration and hydronic work, and state law carves out a special restricted license only for utility employees who repair appliances. Source: Iowa Code Chapter 105, Plumbers, Mechanical Professionals, and Contractors
In Iowa, you can check a license with the Iowa DIAL Find a Record or License (Plumbing & Mechanical Systems Board public search) or report a problem to the Iowa Attorney General Consumer Protection Division.
Before You Book in Waterloo
- If the problem turns out to be the supply valves or the standpipe, do you handle that or should I call a plumber?
- If the washer is leaking, will you find where the water starts before quoting a part?
- If a part has to be ordered, how soon can you come back to finish?
Maytag Washer Repair FAQs: Waterloo, IA
What should I do about a Maytag error code?
Why is my washer leaking?
Do you work for Maytag?
Should I repair or replace my Maytag washer?
Other Washer Repair in Waterloo
More Maytag Washer Repair Pages Nearby
Check the drain hose, the supply valves and (on a front loader) the drain pump filter, and note the model number before calling. It rules out the simple causes and speeds up a Maytag repair.