Serving South Valley, New Mexico and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in South Valley, NM

See which appliance repair companies around South Valley work on washing machines, how far away they are and how customers rate them.

Talk to a washing machine tech near South Valley
One call connects you with a local technician who repairs front-load and top-load washers.
☎(866) 293-4411
✓12 companies listed for South Valley✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. We pull these listings from public business data, remove closed businesses, parts stores and unrelated trades, and put companies that mention washers at the top.

Washer Technicians Serving South Valley, NM

23 repair companies serve South Valley from within 30 miles. Other nearby bases include Albuquerque (14), Belen (3), and Edgewood (2). The farthest listed company is about 29 miles out. Nearest on the list: Appliance Care & Repair, around 2.2 miles out. 8 list washing machine or washer work specifically. The 20 rated companies in range average 4.5 stars.

Washer & Dryer Repair
ASAP Appliance Repair
10409 Montgomery Pkwy NE Ste 203H, Albuquerque, NM 87111
12.3 mi from South Valley
★★★★★ 4.9 (657 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sarah's Appliance Repair LLC
2111 Menaul Blvd NE Ste E, Albuquerque, NM 87107
7.8 mi from South Valley
★★★★★ 4.9 (566 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Appliance Care & Repair
4425 Clear St SW, Albuquerque, NM 87121
2.2 mi from South Valley
★★★★★ 4.8 (84 reviews)
Mentions washers
Washer & Dryer Repair
Mr. Ed's Appliance Repair
10632 Easy St NW, Albuquerque, NM 87114
14.1 mi from South Valley
★★★★★ 4.8 (136 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
10000 Coors Bypass NW, Albuquerque, NM 87114
13.1 mi from South Valley
★★★★½ 4.3 (225 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
6600 Menaul Blvd NE, Albuquerque, NM 87110
9.2 mi from South Valley
★★★★½ 4.4 (368 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Albuquerque Home Pros
2428 Jefferson St NE, Albuquerque, NM 87110
8.4 mi from South Valley
★★★★½ 4.7 (48 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
19554 NM-314, Belen, NM 87002
21.2 mi from South Valley
★★★★ 4.1 (66 reviews)
Mentions washersSaturday hours
Appliance Repair
Ortega's Appliance Service
3235 Vassar Dr NE, Albuquerque, NM 87107
8.4 mi from South Valley
★★★★½ 4.6 (884 reviews)
Appliance Repair
Roy's Appliance.
3518 NM-47, Peralta, NM 87042
13.3 mi from South Valley
★★★★★ 4.9 (45 reviews)
Saturday hours
Appliance Repair
Dalton Service Center
1617 Broadway Blvd NE, Albuquerque, NM 87102
6.7 mi from South Valley
★★★★½ 4.4 (356 reviews)
Appliance Repair
Al's Appliance Center
105 Pleasant View Dr Bldg a, Bernalillo, NM 87004
23.2 mi from South Valley
★★★★★ 4.9 (62 reviews)
Saturday hours

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

Repair market snapshot: South Valley, NM
Appliance repair companies in range (30 mi)23
With 4.5+ stars and at least 10 reviews11
Three nearest companies, miles away2.2, 3.4, 6.7
Mention washer work8
Mention a major washer brand0
Listing Saturday hours17

The leading options for South Valley are ASAP Appliance Repair (12.3 miles away, based in Albuquerque, 4.9 stars from 657 reviews, lists Saturday hours); Sarah's Appliance Repair LLC (7.8 miles away, based in Albuquerque, 4.9 stars from 566 reviews, lists Saturday hours); Appliance Care & Repair (2.2 miles away, based in Albuquerque, 4.8 stars from 84 reviews); Mr. Ed's Appliance Repair (14.1 miles away, based in Albuquerque, 4.8 stars from 136 reviews).

⚡ Skip the calling around: we will find a washer tech for you
☎(866) 293-4411

Signs Your Washing Machine Needs a Technician

  • An error code on the display
  • Water left in the drum after the cycle
  • Washer will not start or the lid or door stays locked
  • Burning smell or a motor that hums without turning

What Usually Goes Wrong

Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.
Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Hoses, seals and the door bootFill hoses age and crack, drain hose clamps loosen, and the rubber door boot on a front loader can tear or trap water. Leaks usually start small under the washer before they show on the floor.

What a Washing Machine Technician Checks

Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Drain pump and filterIf water stays in the drum, the technician checks the drain path first. Most front loaders have a pump filter behind a small panel at the bottom front, and many top loaders hide a pump that can jam on a sock or coin. The pump is then tested for power and blockage.
Drain hose and standpipeThe drain hose runs to a standpipe or laundry sink. A kinked hose, a clog in the standpipe or a hose pushed too far down the pipe can stop draining or siphon water out mid-fill.

Troubleshooting first? Start with washer smells like mildew or washer not draining.

Before Anyone Touches the Washer

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Unplug the washer before servicing or cleaning it; pressing the power button does not disconnect it from the electrical supply. Source: GE Appliances - Washer Owner's Manual

More: where washer leaks come from.

Washing Machine Repair Cost Ranges

A washer repair is usually a single part plus labor. Reference ranges from published cost guides:

50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Local Notes for South Valley

Most washer calls in South Valley come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

New Mexico has no appliance-repair-only license; installing, repairing and servicing natural gas piping and listed gas appliances falls under the Construction Industries Division's MM-2 natural gas fitting classification. Source: CID License Classifications and Scopes (City of Albuquerque)

In New Mexico, you can check a license with the NM Regulation and Licensing Department, Construction Industries: Verify a License or report a problem to the New Mexico Department of Justice (Attorney General), Consumer Protection.

Hiring a Washer Repair Company in South Valley

  • Do you work on front-load and top-load washers, or only one type?
  • Can you give a written estimate before ordering parts?
  • If the washer is leaking, will you find where the water starts before quoting a part?

Washing Machine Repair FAQs: South Valley, NM

What should I check before calling?
Make sure the washer is plugged in and the outlet works, the lid or door closes fully, and both water valves are open. If the washer is leaking, unplug it and turn off both supply valves before doing anything else.
Why is my washer so loud on the spin cycle?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.
What stops a washer from spinning?
An unbalanced load, water that will not drain, or a lid switch or door lock that is not engaging stops most spin cycles. If those check out, a technician looks at the drive belt, motor coupling, motor and control.

Washer Repair by Brand in South Valley

Washing Machine Repair in Nearby Cities

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a South Valley technician a trip for parts.

Tell us what your washer is doing and we will connect you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech