Serving Flushing, Michigan and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Flushing, MI

See which appliance repair companies around Flushing work on washing machines, how far away they are and how customers rate them.

Need washer repair in Flushing?
Call our helpline to be connected with an independent washing machine technician near you.
☎(866) 293-4411
✓12 companies listed for Flushing✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. This page lists independent appliance repair companies serving Flushing and the Genesee County area, with companies that mention washer work shown first.

Washing Machine Repair Companies Near Flushing

Our data shows 20 appliance repair companies inside a 30-mile radius of Flushing. 2 list an address in Flushing, and the rest are spread across Flint (4), Clio (2), and Burton (2). Distances run up to about 30 miles. 5 list washing machine or washer work specifically. The closest is Pointe Appliance Service, about 1.6 miles away. Rated companies nearby average 4.0 stars across 19 businesses.

Washer & Dryer Repair
Sears Appliance Repair
3191 S Linden Rd, Flint, MI 48507
6.6 mi from Flushing
★★★★½ 4.6 (152 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
14283 Fenton Rd, Fenton, MI 48430
18.1 mi from Flushing
★★★★½ 4.6 (115 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
1356 Imlay City Rd, Lapeer, MI 48446
27.7 mi from Flushing
★★★★½ 4.6 (84 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
4290 W Vienna Rd, Clio, MI 48420
8.9 mi from Flushing
★★★★½ 4.3 (74 reviews)
Mentions washersSaturday hours
Appliance Repair
Mid Michigan Laundry Equipment Services
1175 W Vienna Rd, Clio, MI 48420
10.5 mi from Flushing
Mentions washersSaturday hours
Appliance Repair
Kearsley Appliance Repair
2302 S Grand Traverse St, Flint, MI 48503
9.0 mi from Flushing
★★★★★ 4.8 (697 reviews)
Appliance Repair
Pointe Appliance Service
3479 Woodridge Ct, Flushing, MI 48433
1.6 mi from Flushing
★★★★½ 4.7 (12 reviews)
Saturday hours
Appliance Repair
Advanced Appliance Repair
5135 Cedardale Ln, Flushing, MI 48433
1.7 mi from Flushing
★★★★★ 5.0 (6 reviews)
Saturday hours
Appliance Repair
Art Noey Appliance
3800 Tittabawassee Rd, Saginaw, MI 48604
29.8 mi from Flushing
★★★★★ 4.8 (432 reviews)
Saturday hours
Appliance Repair
Nuechterlein Electric Inc
304 List St, Frankenmuth, MI 48734
18.5 mi from Flushing
★★★★½ 4.6 (34 reviews)
Appliance Repair
Art Noey Appliance - Frankenmuth
477 N Main St, Frankenmuth, MI 48734
19.9 mi from Flushing
★★★★ 4.0 (32 reviews)
Appliance Repair
Weed’s Appliances
G4070 Dort Hwy, Burton, MI 48529
11.3 mi from Flushing
★ 1.0 (1 review)

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

By the numbers: technicians near Flushing
Rated 4.5 stars or higher (10+ reviews)8
Distance to the three closest (mi)1.6, 1.7, 5.4
Listing Saturday hours9
Repair companies inside 30 miles20
Name washers or washing machines in their listing5
Mention a major washer brand0

Closest matches for Flushing: Sears Appliance Repair (6.6 miles away, based in Flint, 4.6 stars from 152 reviews, lists Saturday hours); Sears Appliance Repair (18.1 miles away, based in Fenton, 4.6 stars from 115 reviews, lists Saturday hours); Sears Appliance Repair (27.7 miles away, based in Lapeer, 4.6 stars from 84 reviews, lists Saturday hours); Sears Appliance Repair (8.9 miles away, based in Clio, 4.3 stars from 74 reviews, lists Saturday hours).

⚡ Get connected with a washer technician near Flushing
☎(866) 293-4411

When to Call for Washer Repair

  • Water left in the drum after the cycle
  • Washer will not start or the lid or door stays locked
  • Burning smell or a motor that hums without turning
  • Washer fills slowly, will not fill, or keeps filling

The Usual Washer Culprits in Flushing

Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Hoses, seals and the door bootFill hoses age and crack, drain hose clamps loosen, and the rubber door boot on a front loader can tear or trap water. Leaks usually start small under the washer before they show on the floor.
Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.

Inside a Washer Repair Visit

Door boot and leaksOn front loaders the rubber door boot can tear or hold water and debris. A technician follows any leak back to its source, which may be the boot, a hose clamp, the pump, the inlet valve or the tub.
Water level sensingA pressure switch or sensor tells the control how much water is in the tub. A blocked air tube or failed switch can cause overfilling, underfilling or a washer that will not move on to the next step.
Tub bearings and sealA rumble or roar that gets louder as the drum speeds up usually means worn bearings, often after a tub seal has let water reach them. It is one of the bigger repairs, so the technician will compare it with the washer's age and value.

Troubleshooting first? Start with washer not draining or washer smells like mildew.

If Your Washer Is Leaking

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Manufacturers require the washer to be electrically grounded and warn against using an extension cord or modifying the plug. Source: Maytag - High-Efficiency Washer Installation Instructions

Do not make an airtight seal between the drain hose and the standpipe or restrict the hose; standpipe height limits vary by model (Maytag's high-efficiency guide allows 18 to 96 inches). Source: Maytag - High-Efficiency Washer Installation Instructions

More: where washer leaks come from.

Repair or Replace Your Washer?

Most washing machine repairs come down to one part and an hour or two of labor, which is why many are worth pricing before you shop for a new washer. Published ranges:

50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Local Notes for Flushing

Most washer calls in Flushing come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Michigan's licensing lists no separate appliance repair license; gas, heating and refrigeration service work is licensed by work classification under the state mechanical contractor license. Source: LARA: Mechanical Examination, Licensing/Registration & Application Information

In Michigan, you can check a license with the LARA Find / Verify a BCC Licensed Professional or Business or report a problem to the Michigan Department of Attorney General, Consumer Protection.

How to Choose a Washing Machine Technician Near Flushing

  • Do you work on front-load and top-load washers, or only one type?
  • If the problem turns out to be the supply valves or the standpipe, do you handle that or should I call a plumber?
  • If the washer is leaking, will you find where the water starts before quoting a part?

Washing Machine Repair FAQs: Flushing, MI

What should I check before calling?
Make sure the washer is plugged in and the outlet works, the lid or door closes fully, and both water valves are open. If the washer is leaking, unplug it and turn off both supply valves before doing anything else.
Do you cover Flushing and nearby towns?
The companies on this page are within driving distance of Flushing. Each one sets its own service area, so check the distance shown and confirm your address when you call.
Why is my washer leaking?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.
Why is my washer so loud on the spin cycle?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.

Washer Repair by Brand in Flushing

Washing Machine Repair in Nearby Cities

A clear drain filter, open supply valves and the model number in hand make any washer repair in Flushing faster and cheaper.

One call to reach a local washing machine repair company
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech