Serving Junction City, Kansas and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Junction City, KS

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve Junction City.

Need washer repair in Junction City?
Tell us the brand and the problem and we will connect you with a technician near Junction City.
☎(866) 293-4411
✓12 companies listed for Junction City✓Independent, not a manufacturer✓Public ratings & distances

When a washer quits in Junction City, the first question is whether it is a clog or a setting you can clear yourself or a failed part, and that decides whether you need a technician at all. The Junction City list below starts with companies that show washer work in their listings, followed by other appliance repair companies nearby.

Who Repairs Washers Near Junction City

15 repair companies serve Junction City from within 60 miles. 2 list an address in Junction City, and other nearby bases include Salina (5), Topeka (4), and Manhattan (2). 3 list washing machine or washer work specifically. American Appliance Service is the nearest, roughly 0.4 miles from Junction City. Across 14 rated companies, the average public rating is 4.0 stars. Junction City is a smaller market, so expect a longer drive and ask whether a trip charge applies.

Washer & Dryer Repair
Sears Appliance Repair
101 N Washington St, Junction City, KS 66441
1.1 mi from Junction City
★★★★½ 4.4 (152 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
400 S Broadway Blvd, Salina, KS 67401
43.9 mi from Junction City
★★★★½ 4.5 (78 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
1740 SW Wanamaker Rd, Topeka, KS 66604
58.6 mi from Junction City
★★★★ 3.8 (170 reviews)
Mentions washersSaturday hours
Appliance Repair
American Appliance Service
710 W 5th St, Junction City, KS 66441
0.4 mi from Junction City
★★★½ 3.4 (18 reviews)
Appliance Repair
F & C Appliance
6015 Tuttle Terrace, Manhattan, KS 66503
19.2 mi from Junction City
★★★★½ 4.3 (28 reviews)
Appliance Repair
Todd's Appliance Parts & Service
202 Hillside Dr, Council Grove, KS 66846
31.2 mi from Junction City
★★★★★ 5.0 (1 review)
Appliance Repair
Wall's Appliance & Services.
721 4th St, Clay Center, KS 67432
28.3 mi from Junction City
★★★★★ 4.8 (5 reviews)
Saturday hours
Appliance Repair
Potts Plumbing & Appliance Repair
9820 KS-4, Topeka, KS 66614
53.7 mi from Junction City
★★★★½ 4.6 (67 reviews)
Appliance Repair
Doctor Appliance
213 S Broadway Blvd, Salina, KS 67401
43.7 mi from Junction City
★★★★½ 4.5 (30 reviews)
Appliance Repair
Suburban Services Center
213 S Broadway Blvd, Salina, KS 67401
43.7 mi from Junction City
★★★★★ 5.0 (4 reviews)
Appliance Repair
Simurgh Project
1323 Houston St, Manhattan, KS 66502
17.9 mi from Junction City
Appliance Repair
Smoky Valley Appliance Repair
1608 Sycamore St, Salina, KS 67401
44.5 mi from Junction City
★★★★½ 4.6 (73 reviews)

We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.

Washer repair near Junction City at a glance
Companies within 60 miles15
Three nearest companies, miles away0.4, 1.1, 17.9
Open on Saturdays (per listing)6
Mention washer work3
With 4.5+ stars and at least 10 reviews5
Mention a major washer brand0

Closest matches for Junction City: Sears Appliance Repair (1.1 miles away, 4.4 stars from 152 reviews, lists Saturday hours); Sears Appliance Repair (43.9 miles away, based in Salina, 4.5 stars from 78 reviews, lists Saturday hours); Sears Appliance Repair (58.6 miles away, based in Topeka, 3.8 stars from 170 reviews, lists Saturday hours); American Appliance Service (0.4 miles away, 3.4 stars from 18 reviews).

⚡ Skip the calling around: we will find a washer tech for you
☎(866) 293-4411

Signs Your Washing Machine Needs a Technician

  • Water left in the drum after the cycle
  • Washer fills slowly, will not fill, or keeps filling
  • An error code on the display
  • Water on the floor under or in front of the washer

The Usual Washer Culprits in Junction City

Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.

How a Washer Service Call Usually Goes in Junction City

Tub bearings and sealA rumble or roar that gets louder as the drum speeds up usually means worn bearings, often after a tub seal has let water reach them. It is one of the bigger repairs, so the technician will compare it with the washer's age and value.
Drain pump and filterIf water stays in the drum, the technician checks the drain path first. Most front loaders have a pump filter behind a small panel at the bottom front, and many top loaders hide a pump that can jam on a sock or coin. The pump is then tested for power and blockage.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.

Troubleshooting first? Start with washer not draining or washer smells like mildew.

Leaks and Safe Shutoff

Closing the washer's water faucets when the machine is not in use takes pressure off the hoses and valves and limits flooding if a hose gives way. Source: GE Appliances - Washer Owner's Manual

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

More: where washer leaks come from.

Repair or Replace Your Washer?

Most washing machine repairs come down to one part and an hour or two of labor, which is why many are worth pricing before you shop for a new washer. Published ranges:

For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

What Junction City Owners Should Know

Most washer calls in Junction City come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

How to Choose a Washing Machine Technician Near Junction City

  • If the washer is leaking, will you find where the water starts before quoting a part?
  • Is your company licensed where my state requires it, and insured?
  • Will you check the drain pump filter and drain hose before replacing the pump?

Washing Machine Repair FAQs: Junction City, KS

Do you cover Junction City and nearby towns?
The companies on this page are within driving distance of Junction City. Each one sets its own service area, so check the distance shown and confirm your address when you call.
Is my washing machine worth fixing?
Compare the repair quote with the price of a comparable new washer and consider its age. Common repairs such as lid switches, door locks, inlet valves, belts and drain pumps are usually worth doing on a washer that is otherwise in good shape. Our repair-cost guide lists published ranges.
Where is the water under my washer coming from?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.

Brand-Specific Washer Repair, Junction City

More Washing Machine Repair Pages Nearby

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a Junction City technician a trip for parts.

Tell us what your washer is doing and we will connect you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech