Serving Anniston, Alabama and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Anniston, AL

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve Anniston.

Water sitting in the washer in Anniston?
One call connects you with a local technician who repairs front-load and top-load washers.
☎(866) 293-4411
✓12 companies listed for Anniston✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. This page lists independent appliance repair companies serving Anniston and the Calhoun County area, with companies that mention washer work shown first.

Washing Machine Repair Companies Near Anniston

13 repair companies serve Anniston from within 30 miles. 4 of them are based in Anniston itself, and the rest are spread across Gadsden (2), Pell City (2), and Jacksonville (1). 3 of them mention washing machine or washer work in their listing or website. Nearest on the list: BRIAN'S SERVICE CO., around 0.4 miles out. Rated companies nearby average 4.3 stars across 12 businesses.

Washer & Dryer Repair
Sears Appliance Repair
803 Martin St S, Pell City, AL 35128
27.4 mi from Anniston
★★★★½ 4.6 (507 reviews)
Mentions washersSaturday hours
Appliance Repair
Coopers Appliance
1939 Bynum Blvd, Eastaboga, AL 36260
9.4 mi from Anniston
★★★★★ 5.0 (13 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
1001 Rainbow Dr, Gadsden, AL 35901
25.0 mi from Anniston
★★★★½ 4.4 (76 reviews)
Mentions washersSaturday hours
Appliance Repair
Scott's appliance repair LLC
1316 Dearmanville Rd, Anniston, AL 36207
4.9 mi from Anniston
★★★★½ 4.6 (201 reviews)
Saturday hours
Appliance Repair
Gleaning Hands Appliance Repair
2252 Bynum Leatherwood Rd, Anniston, AL 36201
4.9 mi from Anniston
★★★★½ 4.3 (15 reviews)
Appliance Repair
Haynes Sewing Machine Co
1008 Gurnee Ave, Anniston, AL 36201
1.4 mi from Anniston
★★★★½ 4.4 (39 reviews)
Appliance Repair
Southern Fix Appliance Repair
4992 Rainbow Dr, Rainbow City, AL 35906
23.7 mi from Anniston
★★★★★ 4.9 (131 reviews)
Saturday hours
Appliance Repair
BRIAN'S SERVICE CO.
627 Sidney Cir, Anniston, AL 36207
0.4 mi from Anniston
★★★★★ 5.0 (5 reviews)
Saturday hours
Appliance Repair
Quality Appliance Solutions
1955 Pelham Rd S, Jacksonville, AL 36265
7.9 mi from Anniston
★★★★ 3.8 (46 reviews)
Appliance Repair
His Way Appliance Service
167 Lock Haven Cir, Riverside, AL 35135
20.7 mi from Anniston
★★★ 3.0 (2 reviews)
Saturday hours
Appliance Repair
Appliance Parts & Services
2787 Wolf Creek Rd N, Pell City, AL 35125
27.6 mi from Anniston
★★★ 3.2 (26 reviews)
Saturday hours
Appliance Repair
Burnett Appliance Services.
23893 US-411, Ashville, AL 35953
29.2 mi from Anniston
★★★★ 3.9 (8 reviews)
Saturday hours

We do not show business phone numbers. Call our helpline to be connected with a participating technician, or look a company up directly. Always confirm licensing and insurance.

By the numbers: technicians near Anniston
Open on Saturdays (per listing)9
Three nearest companies, miles away0.4, 1.4, 4.9
Mention a major washer brand0
Appliance repair companies in range (30 mi)13
Mention washer work3
Rated 4.5 stars or higher (10+ reviews)4

Closest matches for Anniston: Sears Appliance Repair (27.4 miles away, based in Pell City, 4.6 stars from 507 reviews, lists Saturday hours); Coopers Appliance (9.4 miles away, based in Eastaboga, 5.0 stars from 13 reviews, lists Saturday hours); Sears Appliance Repair (25.0 miles away, based in Gadsden, 4.4 stars from 76 reviews, lists Saturday hours); Scott's appliance repair LLC (4.9 miles away, 4.6 stars from 201 reviews, lists Saturday hours).

⚡ Get connected with a washer technician near Anniston
☎(866) 293-4411

When to Call for Washer Repair

  • An error code on the display
  • Washer fills slowly, will not fill, or keeps filling
  • Water left in the drum after the cycle
  • Musty or mildew smell from the drum or door seal

The Usual Washer Culprits in Anniston

Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.

Inside a Washer Repair Visit

Door boot and leaksOn front loaders the rubber door boot can tear or hold water and debris. A technician follows any leak back to its source, which may be the boot, a hose clamp, the pump, the inlet valve or the tub.
Water level sensingA pressure switch or sensor tells the control how much water is in the tub. A blocked air tube or failed switch can cause overfilling, underfilling or a washer that will not move on to the next step.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.

Troubleshooting first? Start with washer not draining or washer smells like mildew.

Water, Power and Safety First

Closing the washer's water faucets when the machine is not in use takes pressure off the hoses and valves and limits flooding if a hose gives way. Source: GE Appliances - Washer Owner's Manual

Plug the washer into a grounded three-prong outlet on a 15- or 20-amp 120-volt circuit, and never remove the ground prong or use an adapter or extension cord. Source: Whirlpool - Washer Installation Instructions

To prevent siphoning, Whirlpool's instructions limit the drain hose to no more than 8 inches inside a standpipe that is at least 2 inches across and 39 to 96 inches tall, measured from the bottom of the washer. Source: Whirlpool - Washer Installation Instructions

More: where washer leaks come from.

What Washer Repair Costs in Anniston

Most washing machine repairs come down to one part and an hour or two of labor, which is why many are worth pricing before you shop for a new washer. Published ranges:

50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

What Anniston Owners Should Know

Most washer calls in Anniston come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Alabama does not issue a separate appliance repair license, and the state's heating, air conditioning and refrigeration contractor law expressly excludes work on household appliances, residential refrigerators and ice machines. Source: Code of Alabama 1975, Section 34-31-18 et seq. (Alabama Board of Heating, Air Conditioning & Refrigeration Contractors)

In Alabama, you can check a license with the Alabama Plumbers and Gas Fitters Examining Board Individual Licensee Search or report a problem to the Alabama Attorney General's Office, Consumer Interest Division.

Hiring a Washer Repair Company in Anniston

  • If a part has to be ordered, how soon can you come back to finish?
  • How often do you repair your brand washers, and how quickly can you get parts?
  • Can you give a written estimate before ordering parts?

Washing Machine Repair FAQs: Anniston, AL

Why does my front-load washer smell?
Residue from detergent and fabric softener collects in the door boot, the dispenser and the drum. Wipe the boot, clean the dispenser, run the washer's cleaning cycle or a hot empty cycle, and leave the door open between loads.
Why won't my washer spin?
An unbalanced load, water that will not drain, or a lid switch or door lock that is not engaging stops most spin cycles. If those check out, a technician looks at the drive belt, motor coupling, motor and control.
What does a washer repair usually cost?
Most companies charge a service call or diagnostic fee that is often applied to the repair if you go ahead. Common jobs such as a lid switch, inlet valve, drain pump or drive belt are usually worth fixing on a washer that is otherwise sound. Our washing machine repair cost guide lists published ranges.
Why is my washer leaking?
Common sources are a loose or cracked fill hose, the drain hose connection, a torn door boot on a front loader, too much detergent causing suds overflow, or a leaking pump or tub seal. Unplug the washer and shut both valves, then look where the water starts.

Brand-Specific Washer Repair, Anniston

Washing Machine Repair Near Anniston

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a Anniston technician a trip for parts.

One call to reach a local washing machine repair company
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech