A Maytag washer shares most of its basic parts with other washers, but its drive design, lid or door lock, controls and error codes are specific to the brand. We flag companies whose listing or website mentions Maytag and fill in with nearby appliance repair companies so you always have options.
Washing Machine Repair Near Me is independent and not affiliated with Maytag. Listed companies are independent technicians who repair Maytag washers and other brands.
Who Works on Maytag Washers Near Valley Falls
Our data shows 40 appliance repair companies inside a 30-mile radius of Valley Falls. The rest are spread across Providence (12), Pawtucket (9), and North Attleborough (3). The closest is Emergency Appliance Repair Central Falls, about 2.2 miles away. No company within 90 miles of Valley Falls mentions Maytag by name, so these are the nearest appliance repair companies. Most work on several brands, so ask about yours. Rated companies nearby average 4.3 stars across 28 businesses.
Companies are shown by relevance and distance from Valley Falls. A mention does not mean manufacturer certification, so ask each company about its experience with your washer.
| Appliance repair companies in range (30 mi) | 60 |
|---|---|
| Mention Maytag | 0 |
| With 4.5+ stars and at least 10 reviews | 18 |
| Three nearest companies, miles away | 2.2, 2.3, 2.4 |
| Open on Saturdays (per listing) | 42 |
| Mention washer work | 10 |
The leading options for Valley Falls are Wickford Appliance Sales & Service (4.6 miles away, based in Pawtucket, 4.9 stars from 1,432 reviews, lists Saturday hours); Sears Appliance Repair (2.7 miles away, based in North Attleborough, 4.5 stars from 280 reviews, lists Saturday hours); Sears Appliance Repair (9.4 miles away, based in Cranston, 4.5 stars from 281 reviews, lists Saturday hours); Mike H Appliance Repair (2.3 miles away, based in North Attleborough, 5.0 stars from 149 reviews).
Know Your Maytag Washer
What Makes Maytag Washer Repairs Different
Top load HE models use auto-sensing, spinning slowly to estimate the load before adding water in stages, so the water level can look lower than owners expect. Source: Maytag Product Help - Auto Sensing in a Top Load HE Washer
The washer will only run and spin when the lid or door switch senses it is fully closed, and the lid or door locks at the start of a cycle. Source: Maytag Product Help - Washer Not Draining or Spinning? Troubleshooting Guide
Maytag Washer Symptoms and First Checks
- Washer not filling. Maytag says to make sure both faucets are fully open, the inlet hoses are not kinked, and the inlet screens on the water valve are not clogged. Source: Maytag Product Help - Checking the Fill Hoses if the Washer is not Filling
- Washer leaking. Maytag points first to loose inlet hose connections or missing hose washers, then to the drain hose and a backed-up household drain, and to clothes added mid-cycle that raise the water over the tub. Source: Maytag Product Help - Leaking Water Underneath - Washer
What Maytag Washer Codes Mean
| Code | What it means |
|---|---|
| F9E1 | Top load: long drain, usually tied to a kinked, clogged or improperly installed drain hose. Source: Maytag Product Help - F9E1 - Error Code |
| F5E1 | Top load: lid switch problem; the lid may not be fully closed or something is blocking the switch. Source: Maytag Product Help - F5E1 - Error Code |
| F5E3 | Top load: lid lock problem; Maytag suggests a five-minute power reset first. Source: Maytag Product Help - F5E3 - Error Code |
When to Call for Maytag Washer Repair
- Water left in the drum after the cycle
- Musty or mildew smell from the drum or door seal
- Water on the floor under or in front of the washer
How a Washer Service Call Usually Goes in Valley Falls
Owner Care for Maytag Washers
- Clean the front load drain pump filter every few months or as needed to clear lint and debris; check the owner's manual for its location on your model. Source: Maytag Product Help - Cleaning the Pump Filter - Front Load Washer
- On front loaders, wipe and dry the door seal folds, remove wet loads promptly and leave the door slightly open after use to limit mildew and odor. Source: Maytag Product Help - Cleaning a Front Load Washer Door Seal
Brand guides: Maytag Washer Not Draining or Spinning: Causes.
What Maytag Washer Repairs Cost
A Maytag washer repair usually costs about the same as any other brand for the same part. Published ranges:
- Tub / drum bearing replacement: $150–$225 Source: Fixr - How much does it cost to repair a washing machine?
- Water inlet valve replacement: $95–$190 Source: Fixr - How much does it cost to repair a washing machine?
- Agitator replacement: $350–$575 Source: Fixr - How much does it cost to repair a washing machine?
- Control board (motherboard) replacement: $250–$400 Source: Fixr - How much does it cost to repair a washing machine?
- Service call / diagnostic fee (often waived if you go ahead with the repair): $50–$100 per visit Source: Fixr - How much does it cost to repair a washing machine?
For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?
Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.
What to Have Ready for a Maytag Washer Call
- What happens during the cycle (no start, no fill, no drain, no spin, leaks, noise)
- The brand, model and serial number from the label inside the lid, around the door opening or on the back of the cabinet
- How old the washer is
Around Valley Falls
Most washer calls in Valley Falls come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.
Rhode Island does not issue a license named for appliance repair, but its Department of Labor and Training licenses pipefitters and refrigeration technicians, including a limited natural gas service license that covers servicing gas-fueled appliances. Source: Bureau of Pipefitters, Refrigeration Technicians, Sprinklerfitters, Sheet Metal Workers and Oil Heat Contractors (260-RICR-30-15-2)
In Rhode Island, you can check a license with the Contractors' Registration and Licensing Board: Search a Registrant/Licensee or report a problem to the Rhode Island Attorney General, Consumer Protection Unit.
How to Choose a Washing Machine Technician Near Valley Falls
- If the problem turns out to be the supply valves or the standpipe, do you handle that or should I call a plumber?
- If the washer is leaking, will you find where the water starts before quoting a part?
- Will you check the drain pump filter and drain hose before replacing the pump?
Maytag Washer Repair FAQs: Valley Falls, RI
Is this Maytag customer service?
Why won't my washer spin?
Why does my front-load washer smell?
What should I do about a Maytag error code?
Other Washer Repair in Valley Falls
More Maytag Washer Repair Pages Nearby
Before you call, find the model and serial number on your Maytag washer's label, usually inside the lid, around the door opening or on the back of the cabinet. A technician who knows the model can often tell you on the phone what the first visit will involve.