Serving Gladewater, Texas and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in Gladewater, TX

Washing machine repair from independent technicians serving Gladewater, with ratings, distances and what to check before you call.

Water sitting in the washer in Gladewater?
Tell us the brand and the problem and we will connect you with a technician near Gladewater.
☎(866) 293-4411
✓12 companies listed for Gladewater✓Independent, not a manufacturer✓Public ratings & distances

Most washing machine breakdowns trace back to a short list of parts: the drain pump and its filter, the lid switch or door lock, the drive belt or motor coupling, the inlet valve and the suspension. We pull these listings from public business data, remove closed businesses, parts stores and unrelated trades, and put companies that mention washers at the top.

Washing Machine Repair Companies Near Gladewater

16 repair companies serve Gladewater from within 30 miles. The rest are spread across Tyler (6), Longview (5), and Hawkins (1). Nearest on the list: Major Appliance Service, around 9.8 miles out. 3 list washing machine or washer work specifically. Rated companies nearby average 4.0 stars across 15 businesses.

Washer & Dryer Repair
Mr. Appliance of East Texas
3412 S SW Loop 323 Ste B, Tyler, TX 75701
28.0 mi from Gladewater
★★★★½ 4.7 (1,263 reviews)
Mentions washers
Washer & Dryer Repair
Sears Appliance Repair
3510 McCann Rd, Longview, TX 75605
11.4 mi from Gladewater
★★★★½ 4.5 (206 reviews)
Mentions washersSaturday hours
Washer & Dryer Repair
Sears Appliance Repair
4701 S Broadway Ave, Tyler, TX 75703
26.8 mi from Gladewater
★★★½ 3.4 (29 reviews)
Mentions washersSaturday hours
Appliance Repair
1st Rate Appliance Repair
300 Beaulah St Ste. 3, Hawkins, TX 75765
15.3 mi from Gladewater
★★★★★ 4.9 (409 reviews)
Appliance Repair
Alden's Air & Appliance Repair
12309 I H 20 S Service Rd W, Hallsville, TX 75650
22.6 mi from Gladewater
★★★★½ 4.6 (142 reviews)
Saturday hours
Appliance Repair
Major Appliance Service
304 Enterprise St, Longview, TX 75604
9.8 mi from Gladewater
★★★★ 3.8 (81 reviews)
Appliance Repair
Harold's Appliance Repair
509 E Longview St, Arp, TX 75750
22.3 mi from Gladewater
★★★★½ 4.7 (11 reviews)
Appliance Repair
Victory Appliance Service
1912 E SE Loop 323 #155, Tyler, TX 75701
25.1 mi from Gladewater
★★★★★ 5.0 (43 reviews)
Appliance Repair
Appliance ER
1701 S High St, Longview, TX 75602
12.8 mi from Gladewater
★★★½ 3.5 (57 reviews)
Saturday hours
Appliance Repair
A Plus Commercial Kitchens
4547 Cantina Dr, Tyler, TX 75708
21.6 mi from Gladewater
★★★★ 3.8 (21 reviews)
Commercial
Appliance Repair
Johnson Service Center
2131 S Green St, Longview, TX 75602
13.5 mi from Gladewater
★★★★ 4.1 (24 reviews)
Appliance Repair
Ponder Appliance Repair
Birchwood Path, Holly Lake Ranch, TX 75765
17.9 mi from Gladewater
★★★ 3.0 (2 reviews)
Saturday hours

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

Gladewater repair companies in numbers
Mention a major washer brand0
Mention washer work3
Rated 4.5 stars or higher (10+ reviews)6
Companies within 30 miles16
Open on Saturdays (per listing)5
Three nearest companies, miles away9.8, 11.3, 11.4

At the top of the Gladewater list: Mr. Appliance of East Texas (28.0 miles away, based in Tyler, 4.7 stars from 1,263 reviews); Sears Appliance Repair (11.4 miles away, based in Longview, 4.5 stars from 206 reviews, lists Saturday hours); Sears Appliance Repair (26.8 miles away, based in Tyler, 3.4 stars from 29 reviews, lists Saturday hours); 1st Rate Appliance Repair (15.3 miles away, based in Hawkins, 4.9 stars from 409 reviews).

⚡ One call to reach a local washing machine repair company
☎(866) 293-4411

When to Call for Washer Repair

  • Washer will not spin, or clothes come out soaking wet
  • An error code on the display
  • Washer fills slowly, will not fill, or keeps filling
  • Musty or mildew smell from the drum or door seal

Why Washing Machines Break Down

Suspension and bearingsShock absorbers, dampers and springs hold the tub steady during the spin. When they wear, the washer bangs and walks. Worn drum bearings make a rumbling or grinding noise that gets louder on the spin cycle.
Drain pumps and filtersSocks, coins, hair ties and lint end up in the drain path. On most front loaders a small filter behind a panel at the bottom front catches them, and a clogged filter or jammed pump is behind many not-draining calls.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.

How a Washer Service Call Usually Goes in Gladewater

Suspension and shocksShock absorbers, dampers or suspension rods keep the tub from slamming during the spin. Worn parts cause banging, off-balance shutdowns and a washer that walks across the floor.
Controls and error codesElectronic washers report faults with codes. The technician reads the code and runs the brand's test mode where there is one, then checks wiring and the control board before ordering it, since boards are among the costlier parts.
Drain pump and filterIf water stays in the drum, the technician checks the drain path first. Most front loaders have a pump filter behind a small panel at the bottom front, and many top loaders hide a pump that can jam on a sock or coin. The pump is then tested for power and blockage.

Troubleshooting first? Start with washer not spinning or front-load vs top-load washer problems.

Water, Power and Safety First

Closing the washer's water faucets when the machine is not in use takes pressure off the hoses and valves and limits flooding if a hose gives way. Source: GE Appliances - Washer Owner's Manual

Manufacturers require the washer to be electrically grounded and warn against using an extension cord or modifying the plug. Source: Maytag - High-Efficiency Washer Installation Instructions

To prevent siphoning, Whirlpool's instructions limit the drain hose to no more than 8 inches inside a standpipe that is at least 2 inches across and 39 to 96 inches tall, measured from the bottom of the washer. Source: Whirlpool - Washer Installation Instructions

More: where washer leaks come from.

Repair or Replace Your Washer?

Before replacing a washer in Gladewater, price the repair. Here is what published cost guides report for common jobs:

For a drum repair, consider replacing the washer instead if it is more than five years old or has had frequent problems. Source: HomeAdvisor - How Much Do Washing Machine Repairs Cost?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

Around Gladewater

Most washer calls in Gladewater come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Texas has no separate appliance repair license; under the Plumbing License Law, appliance dealers and their employees may install and service appliances (other than water heaters) without a plumbing license when hooking up to existing openings with a code-approved appliance connector, while other gas or water piping work generally requires a plumbing license. Source: Plumbing License Law, Tex. Occ. Code ch. 1301, ยง1301.053 (Texas State Board of Plumbing Examiners)

In Texas, you can check a license with the Texas plumbing Public License Search or report a problem to the Texas Attorney General, Consumer Protection Division.

Questions to Ask a Gladewater Washer Technician

  • If a part has to be ordered, how soon can you come back to finish?
  • What guarantee do you give on parts and labor?
  • What is the service call or diagnostic fee, and is it applied to the repair?

Washing Machine Repair FAQs: Gladewater, TX

Are you affiliated with any washer brand?
No. We are an independent directory and are not affiliated with any appliance manufacturer. Our helpline connects you with a participating independent technician. If your washer is still under manufacturer coverage, contact the brand first.
Is there anything I can try first?
Make sure the washer is plugged in and the outlet works, the lid or door closes fully, and both water valves are open. If the washer is leaking, unplug it and turn off both supply valves before doing anything else.
Why does my washer shake or walk across the floor?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.

Brand-Specific Washer Repair, Gladewater

Washing Machine Repair Near Gladewater

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a Gladewater technician a trip for parts.

Skip the calling around: we will find a washer tech for you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech