Serving White City, Oregon and nearby areas Helpline · (866) 293-4411
☎(866) 293-4411Call

Washing Machine Repair in White City, OR

Water left in the drum, a washer that will not spin or a puddle on the laundry room floor? Here are the companies that serve White City.

Washer down in White City?
Call our helpline to be connected with an independent washing machine technician near you.
☎(866) 293-4411
✓11 companies listed for White City✓Independent, not a manufacturer✓Public ratings & distances

A washer that stops mid-cycle with a drum full of water turns a normal laundry day into a mess of wet towels and trips to the laundromat. The White City list below starts with companies that show washer work in their listings, followed by other appliance repair companies nearby.

Who Repairs Washers Near White City

11 repair companies serve White City from within 60 miles. The rest are spread across Medford (4), Grants Pass (3), and Klamath Falls (2). Distances run up to about 59 miles. 3 of them mention washing machine or washer work in their listing or website. Surgeon Family Appliance is the nearest, roughly 6.7 miles from White City. The 11 rated companies in range average 4.6 stars. White City is a smaller market, so expect a longer drive and ask whether a trip charge applies.

Washer & Dryer Repair
Sears Appliance Repair
1533 NE F St, Grants Pass, OR 97526
24.4 mi from White City
★★★★ 4.2 (125 reviews)
Mentions washersSaturday hours
Appliance Repair
Umpqua Appliance
110 N Main St, Winston, OR 97496
56.2 mi from White City
★★★★★ 4.8 (529 reviews)
Mentions washers
Appliance Repair
C&R Appliance Services
718 Black Oak Dr STE A, Medford, OR 97504
8.0 mi from White City
★★★★★ 4.8 (438 reviews)
Washer & Dryer Repair
Sears Appliance Repair
4311 S 6th St, Klamath Falls, OR 97603
58.1 mi from White City
★★★★½ 4.6 (15 reviews)
Mentions washersSaturday hours
Appliance Repair
Just-in Time Appliance Repair
328 S Central Ave #208, Medford, OR 97501
7.7 mi from White City
★★★★★ 4.8 (233 reviews)
Saturday hours
Appliance Repair
Immortal Appliance Repair
224 Gordon Way S, Grants Pass, OR 97527
22.1 mi from White City
★★★★★ 5.0 (36 reviews)
Saturday hours
Appliance Repair
Interstate Appliance Service
817 N Central Ave # C, Medford, OR 97501
7.2 mi from White City
★★★★½ 4.5 (33 reviews)
Appliance Repair
Surgeon Family Appliance
1513 N Riverside Ave, Medford, OR 97501
6.7 mi from White City
★★★★ 3.9 (142 reviews)
Saturday hours
Appliance Repair
Just-in Time Appliance Repair LLC
1550 Rogue River Hwy, Grants Pass, OR 97527
24.3 mi from White City
★★★★½ 4.7 (346 reviews)
Appliance Repair
CHC Appliance and Repair LLC
914 Oak Ave, Klamath Falls, OR 97601
55.7 mi from White City
★★★★★ 4.9 (75 reviews)
Saturday hours
Appliance Repair
Restore Appliances LLC
2673 NE Diamond Lake Blvd, Roseburg, OR 97470
59.4 mi from White City
★★★★ 4.2 (85 reviews)
Saturday hours

Listings come from public business data. A brand or service mention means the company names it in its listing or website; it is not a certification. Verify experience, licensing and insurance before hiring.

Repair market snapshot: White City, OR
Mention a major washer brand0
Rated 4.5 stars or higher (10+ reviews)8
Distance to the three closest (mi)6.7, 7.2, 7.7
Listing Saturday hours7
Name washers or washing machines in their listing3
Companies within 60 miles11

First up for White City: Sears Appliance Repair (24.4 miles away, based in Grants Pass, 4.2 stars from 125 reviews, lists Saturday hours); Umpqua Appliance (56.2 miles away, based in Winston, 4.8 stars from 529 reviews); C&R Appliance Services (8.0 miles away, based in Medford, 4.8 stars from 438 reviews); Sears Appliance Repair (58.1 miles away, based in Klamath Falls, 4.6 stars from 15 reviews, lists Saturday hours).

⚡ One call to reach a local washing machine repair company
☎(866) 293-4411

When to Call for Washer Repair

  • An error code on the display
  • Water left in the drum after the cycle
  • Washer will not spin, or clothes come out soaking wet
  • Washer fills slowly, will not fill, or keeps filling

The Usual Washer Culprits in White City

Water inlet valveAn electric valve behind the washer lets hot and cold water in. When it sticks or its screens clog, the washer fills slowly, not at all, or keeps filling.
Belts, couplers and motorsDepending on the design, the motor turns the drum through a belt, a motor coupling or a direct-drive rotor. A worn belt, broken coupler or failed motor leaves the drum still while the washer hums or fills.
Lid switches and door locksA washer will not fill, agitate or spin unless the lid switch or door lock tells the control the lid or door is shut and locked. A worn switch or failed lock is one of the most common parts replaced.

Inside a Washer Repair Visit

Drive belt, coupler and motorBelt-drive washers turn the drum with a belt; others use a motor coupling or a direct-drive motor bolted to the tub. A hum with no movement, a burning smell or a drum that turns by hand too easily points here.
Drain pump and filterIf water stays in the drum, the technician checks the drain path first. Most front loaders have a pump filter behind a small panel at the bottom front, and many top loaders hide a pump that can jam on a sock or coin. The pump is then tested for power and blockage.
Lid switch or door lockTop loaders use a lid switch or lid lock and front loaders use a door lock. If the control cannot confirm the lid or door is shut and locked, the washer will not fill, agitate or spin, and a technician tests the switch and its wiring.

Troubleshooting first? Start with washer not spinning or washer not draining.

Leaks and Safe Shutoff

Always install new inlet hoses rather than reusing old ones, check them from time to time, and replace any hose that shows bulges, kinks, cuts, wear or leaks. Source: Whirlpool - Washer Installation Instructions

Manufacturers require the washer to be electrically grounded and warn against using an extension cord or modifying the plug. Source: Maytag - High-Efficiency Washer Installation Instructions

Do not let children play in, on or with a washer, and remove the lid or door before a washer is discarded or taken out of service so a child cannot become trapped inside. Source: GE Appliances - Washer Owner's Manual

More: where washer leaks come from.

Repair or Replace Your Washer?

A washer repair is usually a single part plus labor. Reference ranges from published cost guides:

50% rule: if the repair would cost more than half the price of a comparable new washer, replacing it is usually the better buy. Source: Fixr - How much does it cost to repair a washing machine?

Ranges are published estimates, not quotes. See the washing machine repair cost guide and whether to repair or replace a washer.

What White City Owners Should Know

Most washer calls in White City come down to the same handful of parts: the drain pump and filter, the lid switch or door lock, the drive belt or coupler, the inlet valve and the suspension.

Oregon has no license issued specifically for appliance repair that we could confirm, but anyone installing or servicing liquefied petroleum (LP) gas appliances needs an LP gas fitter license from the Oregon State Fire Marshal. Source: Liquefied Petroleum Gas licensing (Oregon State Fire Marshal)

In Oregon, you can check a license with the Oregon Construction Contractors Board Contractor/License Search or report a problem to the Oregon Department of Justice, Consumer Protection.

How to Choose a Washing Machine Technician Near White City

  • If the problem turns out to be the supply valves or the standpipe, do you handle that or should I call a plumber?
  • If a part has to be ordered, how soon can you come back to finish?
  • What is the service call or diagnostic fee, and is it applied to the repair?

Washing Machine Repair FAQs: White City, OR

Should I repair or replace my washer?
Compare the repair quote with the price of a comparable new washer and consider its age. Common repairs such as lid switches, door locks, inlet valves, belts and drain pumps are usually worth doing on a washer that is otherwise in good shape. Our repair-cost guide lists published ranges.
What stops a washer from spinning?
An unbalanced load, water that will not drain, or a lid switch or door lock that is not engaging stops most spin cycles. If those check out, a technician looks at the drive belt, motor coupling, motor and control.
Why is my washer so loud on the spin cycle?
An unbalanced load is the most common cause, followed by a washer that is not level. If it keeps happening with balanced loads on a level floor, worn shock absorbers, suspension springs or drum bearings are the likely cause, and a technician should check them.

Find Your Washer Brand in White City

Washing Machine Repair in Nearby Cities

Write down the model and serial number from the label (inside the lid or door frame, or on the back of the cabinet) and note any error code. It saves a White City technician a trip for parts.

Skip the calling around: we will find a washer tech for you
☎(866) 293-4411
☎ Call (866) 293-4411 Talk to a tech